Use the "Move Left" and "Move Right" links below
to navigate around the machine. Featured areas in the image are numbered and
described in the "Featured Areas" section located below the image.
Featured Areas |
(1) |
The trim station is the cutting assembly and
is often air operated and contains the cutting assembly. The cutting assembly on the
trim station uses hydraulic pressure to finish the die cutting process. A toggle
system is used to extend and retract the trim die. [Photo description:
The highlighted area includes silver, black, and orange moving metal parts of the
machine.] View close-up |
(2) |
The mechanical safety device
is an energy isolating device because it physically prevents
movement of the platen during setup and/or adjustment. All
blocking and pinning devices are used in accordance with
established energy control (lockout/tagout) procedures. An
important point to consider in the design of mechanical safety
devices is that they must be able to withstand the forces
exerted by the hazard without presenting a hazard themselves. [Photo description:
The highlighted area includes a red metal brace wedged in between two moving parts
preventing them from coming together.] View close-up |
(3) |
This is the top of the Hang Hole Remover.
This device acts as a stripper and separator and removes internal die cuts. [Photo description:
The highlighted area includes silver, black, and orange moving metal parts of the
machine.] View close-up |
Accessibility Assistance: Contact the OSHA Directorate of Technical Support and Emergency Management at (202) 693-2300 for assistance accessing OSHA graphics.
|