eTools Home : Logging  Standards | Glossary | Bibliography | User Guide | Credits
Logging eTool
 
Incorrect Backcutting

Incorrect Backcutting The OSHA standard requires that the backcut be made above the level of the horizontal facecut. This will create a step to keep the tree from sliding back across the stump. [29 CFR 1910.266(h)(2)(vii)]  
Kinds of Incorrect Back Cuts:
 
Back cut at the same level as a horizontal facecut
  
Back cut at the same level as a horizontal facecut   Highly increases the possibility of the tree butt kicking-back off the stump and decreases elasticity of the hinge.
 
Back cut too deep
 
Back cut too deep   The hinge will break almost immediately resulting in inaccurate felling, and possible damage to the bar or saw.

Back cut too high above the notch
 
Back cut too high above the notch   Highly increases the necessity of pushing or pulling the tree to make it fall; produces low quality butt and also decreases the effectiveness of the notch.
 
Back cut below the notch
Back cut below the notch   Highly increases the possibility of the tree sitting back on the stump; produces a low quality butt and also may require pushing.
Sloping back cut
Sloping back cut   Lessens the effectiveness of the hinge or leaves an inaccurate hinge, producing a low quality butt and wasted material.
Angle back cut with inadequate notch
Angle back cut with inadequate notch   Increased possibility of barber chairing, hinge breaks early, resulting in loss of felling control and a low quality butt.
Book Additional Information:
<< Back to The Back Cut  |  << Back to The Conventional Back Cut


 

eTools Home : Logging  Standards | Glossary | Bibliography | User Guide | Credits