Molds

Standards

Mold is addressed in specific OSHA standards for general industry, shipyard employment and construction. This section highlights OSHA standards and documents related to mold.

OSHA Standards
General Industry (29 CFR 1910)
General Industry (29 CFR 1910)
Related Information

1910 Subpart J - General Environmental Controls

1910.141, Sanitation.

Related Information
Maritime (29 CFR 1915, 1917, 1918)
Maritime (29 CFR 1915, 1917, 1918)
Related Information

1915

Related Information
Construction (29 CFR 1926)
Construction (29 CFR 1926)
Related Information

1926 Subpart D

1926.51, Sanitation.

Related Information
State Standards

There are 28 OSHA-approved State Plans, operating state-wide occupational safety and health programs. State Plans are required to have standards and enforcement programs that are at least as effective as OSHA's and may have different or more stringent requirements.

Additional Federal Register notices

Note: The notices in this list provide additional information that is not necessarily connected to a specific OSHA standard highlighted on this Safety and Health Topics page.


Additional Letters of Interpretation

Note: The letters in this list provide additional information that is not necessarily connected to a specific OSHA standard highlighted on this Safety and Health Topics page.


National Consensus and Industry Standards

Note: These are NOT OSHA regulations. However, they do provide guidance from their originating organizations related to worker protection.

American National Standards Institute (ANSI)/American Society of Heating, Refrigerating, and Air Conditioning Engineers (ASHRAE)

  • 62.1, Ventilation for Acceptable Indoor Air Quality. Sets minimum ventilation rates and other requirements for commercial and institutional buildings.

Institute of Inspection, Cleaning and Restoration Certification (IICRC)

  • S500, Standard and Reference Guide for Professional Water Damage Restoration. Provides a specific set of practical standards for water damage restoration. It does not attempt to teach comprehensive water damage restoration procedures; rather it provides the foundation for basic principles of proper restoration practices.
  • S520, Standard and Reference Guide for Professional Mold Remediation. Establishes mold contamination definitions, descriptions and conditions (1, 2, 3), and general guidance, which, when properly applied, can assist remediators and others in determining criteria that trigger remediation activities or confirm remediation success.