A 44 ft. tall reinforcing steel cage weighing 80 tons fell over and killed one of the two workers working near the top of the cage. The deceased worker was caught between the collapsing reinforcing cage and the concrete footing surface. At the time of the incident, the two workers were installing horizontal ties. The wind at the time of the incident was about 25 mph.

A pile top drill unit and a 206 feet long pipe casing, 68-inch diameter suddenly dropped 25 feet into the soft ocean sediment bed as the crane of the jack-up barge was releasing a 80 ton bottom hole assembly onto the platform of the drill unit. The fall of the drill unit caused injuries to three employees working on the platform. One of them was fatal. The steel casing was horizontally held above sea level by the jack-up barge, which was supported on four legs, each 7.5 feet square in cross-section.

The project consisted of construction of a six-story parking garage. The 55-foot long mast climbing platform consisted of 20 foot fixed platform plus extensions on either side supported in the center by a single mast. Three sections, each 5-foot long were installed on one side, and four sections were installed on the other side. The side, which had four sections collapsed. 3 workers were injured.