Appendix A to § 1910.1200 - Health Hazard Criteria (Mandatory)

A.0 General Classification Considerations

A.0.1 Classification

A.0.1.1 The term "hazard classification" is used to indicate that only the intrinsic hazardous properties of chemicals are considered. Hazard classification incorporates three steps:

(a) Identification of relevant data regarding the hazards of a chemical;

Substance Safety Data Sheet and Technical Guidelines for Methylene Chloride

1. Substance Identification

Appendix A to § 1910.1048 - Substance Technical Guidelines for Formalin

Appendix D to § 1910.1047 - Sampling and Analytical Methods for Ethylene Oxide (Non-Mandatory)

A number of methods are available for monitoring employee exposures to EtO. Most of these involve the use of charcoal tubes and sampling pumps, followed by analysis of the samples by gas chromatograph. The essential differences between the charcoal tube methods include, among others, the use of different desorbing solvents, the use of different lots of charcoal, and the use of different equipment for analysis of the samples.

Appendix B to § 1910.1025 - Employee Standard Summary

This appendix summarizes key provisions of the standard that you as a worker should become familiar with.

i. permissible exposure limit (pel) - paragraph (c)

Appendix B to § 1910.1020 - Availability of NIOSH Registry of Toxic Effects of Chemical Substances (RTECS) (Non-Mandatory)

Appendix C to § 1910.1018 - Medical Surveillance Guidelines

I. General

I. SUBSTANCE IDENTIFICATION

A. Substance. Inorganic Arsenic.

B. Definition. Copper acetoarsenite, arsenic and all inorganic compounds containing arsenic except arsine, measured as arsenic (As).

C. Permissible Exposure Limit. 10 micrograms per cubic meter of air as determined as an average over an 8-hour period. No employee may be exposed to any skin or eye contact with arsenic trichloride or to skin or eye contact likely to cause skin or eye irritation.

Appendix J to § 1910.1001 - Polarized Light Microscopy of Asbestos - Non-Mandatory

Method number: ID-191
Matrix: Bulk

COLLECTION PROCEDURE

Collect approximately 1 to 2 grams of each type of material and place into separate 20 mL scintillation vials.

ANALYTICAL PROCEDURE