Using slide locks in lieu of die blocks on mechanical power presses.

Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

December 21, 1998

Mr. David L. Thorpe
Manufacturing Engineer
General Motors
Metal Fabricating Division Headquarters
5607 New King Street
Troy, Michigan 48098

Dear Mr. Thorpe:

Lock out/Tag out (LOTO) requirements for die-setting operations in hydraulic power presses.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.


April 22, 2005

Mr. William H. Kincaid
Lockton Companies of St. Louis
Three City Place Drive
Suite 900
St. Louis, MO 63141

Dear Mr. Kincaid: