Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Inspection Detail

Inspection: 314759333 - Searing Industries

Inspection Information - Office: Ca South (Hh Unit)

Nr: 314759333Report ID: 0950662Open Date: 03/20/2012

Searing Industries
8901 Arrow Route
Rancho Cucamonga, CA 91730
Union Status: NonUnion
SIC: 3317/Steel Pipe and Tubes
NAICS: 331210/Iron and Steel Pipe and Tube Manufacturing from Purchased Steel

Inspection Type:Accident
Scope:Partial Advanced Notice:N
Ownership:Private
Safety/Health:Safety Close Conference:07/25/2012
Planning Guide: Safety-Manufacturing Close Case:06/17/2013
Emphasis: S:Targeted Compl & Consult

Related Activity:TypeIDSafetyHealth
 Accident101695351    

Violation Summary
Serious Willful Repeat Other Unclass Total
Initial Violations 1 1 2
Current Violations 1 1 2
Initial Penalty $18,000 $0 $0 $5,000 $0 $23,000
Current Penalty $9,000 $0 $0 $5,000 $0 $14,000
FTA Amount $0 $0 $0 $0 $0 $0

Violation Items
# ID Type Standard Issuance Abate Curr$ Init$ Fta$ Contest LastEvent
  1. 01001 Other 342 A 07/25/2012 08/24/2012 $5,000 $5,000 $0 07/30/2012 F - Formal Settlement
  2. 02001 Serious 4002 A 07/25/2012 08/01/2012 $9,000 $18,000 $0 07/30/2012 F - Formal Settlement

Accident Investigation Summary
Summary Nr: 201694320Event: 03/19/2010Employee Amputates Fingers In Metal Fabricating Machine
At approximately 1:15 p.m. on March 19, 2010, Employee #1 fabricating metal tubing from sheet metal on the Tube Mill #4 in Department 501. On Tube Mill #4, an estimated eight-inch open area existed between the run-out table and the end of the metal frame of the cut-off system. A metal, hydraulic cylinder (reciprocating, horizontal, estimated three-inches diameter) moved in and out of this open area. This cylinder was part of the cut-off system. Employee #1, working on the run-out table, placed his left hand in a section of this open area. The cylinder moved outward toward the run-out table and pinned Employee #1's ring and middle fingers on his left hand against the table, amputating them. Employee #1 was employed by Searing Industries who fabricated sheet metal into tubing of varying lengths and sizes. The cause of this accident was failure for the parts of this mill (exposed hydraulic cylinder and run-off table), which created a hazardous pinch point, to be guarded.
Keywords: amputated, cylinder, finger, pinned, metal sheet, unguarded
Inspection Degree Nature Occupation
1 314759333 Hospitalized injury Amputation Machine operators, not specified

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close