Powered by GoogleTranslate

Inspection Detail

Inspection: 314245820 - R.H. Sheppard Company, Incorporated

Inspection Information - Office: Harrisburg Area Office

 

Inspection Nr: 314245820
Report ID: 0316700
Date Opened: 05/23/2011

Site Address:
R.H. Sheppard Company, Incorporated
447 East Middle Street
Hanover, PA 17331

Mailing Address:
101 Philadelphia Street, P.O. Box 877, Hanover, PA 17331

Union Status: NonUnion

SIC:3543

NAICS: 332997/Industrial Pattern Manufacturing


Inspection Type: Referral

Scope: Partial

Advanced Notice: N

Ownership: Private

Safety/Health: Safety

Close Conference: 07/18/2011

Emphasis: S:Amputations

Case Closed: 09/12/2011


Related Activity
Type Activity Nr Safety Health
Referral 200574820 Yes
Violation Summary
Violations/Penalties Serious Willful Repeat Other Unclass Total
Initial Violations 4 4
Current Violations 4 4
Initial Penalty $21,000 $0 $0 $0 $0 $21,000
Current Penalty $10,500 $0 $0 $0 $0 $10,500
FTA Penalty $0 $0 $0 $0 $0 $0

Violation Items
# Citation ID Citation Type Standard Cited Issuance Date Abatement Due Date Current Penalty Initial Penalty FTA Penalty Contest Latest Event Note
1. 01001 Serious 5A0001 08/10/2011 09/05/2011 $3,500 $7,000 $0 I - Informal Settlement  
2. 01002 Serious 19100147 C07 IA 08/10/2011 08/15/2011 $1,500 $3,000 $0 I - Informal Settlement  
3. 01003 Serious 19100147 F01 08/10/2011 09/05/2011 $3,500 $7,000 $0 I - Informal Settlement  
4. 01004 Serious 19100303 F01 08/10/2011 09/05/2011 $2,000 $4,000 $0 I - Informal Settlement  

Investigation Summary

Investigation Nr: 200571628
Event: 05/23/2011
Employee's Arm Is Caught by Conveyor and Is Amputated

On May 23, 2011, Employee #1 and a coworker, both maintenance employees, were cleaning sand out of a belt conveyor because it went off track due to excess flow of sand from a mixer. One of the employees removed part of the tail pulley guard to adjust the bearings. In addition, they tried to remove the sand with shovels but the task was too overwhelming. The maintenance supervisor was consulted. He sent three additional employees to assist with the situation. Employees were positioned across a 40 ft wide mezzanine deck with one of them located at the control panel. The maintenance lead signaled the control operator to turn on or off the belt conveyor. When the conveyor was off, the employees would go in and under the conveyor belt to remove the sand using their arms, hands, shovels, and a vacuum cleaner. The maintenance lead would then signal to turn on the belt conveyor. This went on for approximately three to four times. While the belt conveyor was supposed to be turned off, Employee #1 was using his left hand and arm to clean out the excess sand near the unguarded tail pulley. The control panel operator turned on the belt conveyor that caught and amputated his left arm in the tail pulley. He was taken to a medical center, where he underwent surgical procedures and was then hospitalized for postoperative care.

Keywords: AMPUTATED, BELT CONVEYOR, CAUGHT BY, CONVEYOR, ARM

Investigated Inspection
# Inspection Age Sex Degree of Injury Nature of Injury Occupation
1 314245820 Hospitalized injury Amputation Occupation not reported
Back to Top

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close