Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Inspection Detail

Inspection: 311725071 - Aman Environmental Construction

Inspection Information - Office: Ca Sacramento M&T District Office

Nr: 311725071Report ID: 0950651Open Date: 10/30/2008

Aman Environmental Construction
Cordelia Calif Behind Chp Scales
Cordelia, CA 94533
Union Status: Union
SIC: 1429/Crushed and Broken Stone, Not Elsewhere Classified
NAICS: 212319/Other Crushed and Broken Stone Mining and Quarrying
Mailing: 614 E Edna Place, Covina, CA 91723

Inspection Type:Accident
Scope:Complete Advanced Notice:N
Ownership:Private
Safety/Health:Safety Close Conference:11/19/2008
Emphasis: L:TunnelClose Case:01/15/2011

Related Activity:TypeIDSafetyHealth
 Accident101510410    

Violation Summary
Serious Willful Repeat Other Unclass Total
Initial Violations 1 1 2
Current Violations 1 1 2
Initial Penalty $12,600 $0 $0 $225 $0 $12,825
Current Penalty $10,125 $0 $0 $225 $0 $10,350
FTA Amount $0 $0 $0 $0 $0 $0

Violation Items
# ID Type Standard Issuance Abate Curr$ Init$ Fta$ Contest LastEvent
  1. 01001 Other 7016 I 12/12/2008 10/30/2008 $225 $225 $0 01/15/2009 F - Formal Settlement
  2. 02001 Serious 4002 A 12/12/2008 10/30/2008 $10,125 $12,600 $0 01/15/2009 F - Formal Settlement

Accident Investigation Summary
Summary Nr: 201510633Event: 10/13/2008Employee'S Arm Is Injured When Caught In Conveyor Belt
On October 13, 2008 , Employee #1 was attempting to train a 48 inch wide conveyor belt that was riding to one side and rubbing the metal frame of the conveyor. The employee was using a short handle sledge hammer to strike the mounting frame of the return idler on the underside of the conveyor belt to steer the belt back to the center line. The employee adjusted one side of the idler and was turning to adjust the opposite side, when his right arm was drawn into the pinch point between the belt and idler. There was a factory piece of a quarter inch sheet metal that was spanning the width of the frame of the conveyor and was three inches above the top surface of the idler. Employee #1's arm was drawn into this gap between the sheet metal, belt, and idler. The motion of the belt wedged the arm of the employee into the pinch point up to his arm pit. The belt stalled due to the restriction on the belt, and Employee #1 was found in that position. He was extracted and transported to the hospital by the site foreman. He was discharged on October 18, 2008 following several surgeries to his upper and lower right arm to repair damaged blood vessels, tissue and to repair a broken finger tip on his right ring finger.
Keywords: finger, caught between, arm, conveyor belt
Inspection Degree Nature Occupation
1 311725071 Hospitalized injury Other Millwrights

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close