Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Inspection Detail



Violation Summary
Serious Willful Repeat Other Unclass Total
Initial Violations 4 4
Current Violations 2 2
Initial Penalty $15,750 $0 $0 $0 $0 $15,750
Current Penalty $10,350 $0 $0 $0 $0 $10,350
FTA Amount $0 $0 $0 $0 $0 $0

Violation Items
# ID Type Standard Issuance Abate Curr$ Init$ Fta$ Contest LastEvent
  1. 01001 Serious 1550053001 B 04/08/2002 03/26/2002 $6,300 $6,300 $0 04/15/2002 F - Formal Settlement
  2. 01002 Serious 1550053001 A 04/08/2002 03/26/2002 $4,050 $4,050 $0 04/15/2002 F - Formal Settlement
Deleted 3. 01003 Serious 1550010001 C 04/08/2002 03/26/2002 $2,700 $2,700 $0 04/15/2002 F - Formal Settlement
Deleted 4. 01004 Serious 1550011002 04/08/2002 03/26/2002 $2,700 $2,700 $0 04/15/2002 F - Formal Settlement

Accident Investigation Summary
Summary Nr: 170238901 Event: 01/26/2002Employee Killed When Caught In Elevator Machinery
At approximately 1:00 a.m. on January 26, 2002, Employee #1 of CBI Services was part of a crew servicing an Alimak Elevator at a construction site located at the Tesoro Refinery in Anacortes, WA. Two coworkers were in the elevator car, while Employee #1 was on top of the car greasing the rollers located along the corners of the mast and at the bottom of the counterweight. Apparently the operator thought he heard a signal to run the elevator up. When he did this, Employee #1 was bent over between two guardrail posts that are around the top of the car and over the counterweight hitch. According to eyewitnesses, he appeared to be reaching out with his right arm to grease the bottom rollers of the counterweight. His head appears to have been in line with the bottom of the counterweight and one of the mast braces. When the elevator went up, it appears that the counterweight came down and crushed his head against a mast brace. The counterweight hitch (that is attached to the elevator car top) appears to have then pushed his upper torso against a tower support. The victim suffered traumatic crushing head wounds and fracture wounds to his upper left torso. He was transported to a hospital in Anacortes where he was pronounced dead. It appears that two coworkers, including the victim's foreman, were trained on a different type of elevator, and did not know that the operator's control box was portable and should have been on top of the elevator under the direct supervision of Employee #1. The red shut-off button on the top and other safety power interrupt features were not used.
Keywords: head, maintenance, counterbalance, construction, torso, lockout, caught between, crushed, elevator, elevator shaft
Inspection Degree Nature Occupation
1 304827652 Fatality Fracture Occupation not reported

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close