Translate
Inspection Detail
Inspection: 125885574 - K&N Engineering
Inspection Information - Office: San Bernardino District Office
Site Address:
K&N Engineering
561 Iowa Ave
Riverside, CA 92502
Mailing Address:
, , 00000
Union Status: NonUnion
SIC:3714
NAICS: 336399/All Other Motor Vehicle Parts Manufacturing
Inspection Type: Accident
Scope: Partial
Advanced Notice: N
Ownership: Private
Safety/Health: Safety
Close Conference: 01/25/2005
Emphasis:
Case Closed: 10/09/2006
| Type | Activity Nr | Safety | Health |
|---|---|---|---|
| Accident | 101157717 |
| Violations/Penalties | Serious | Willful | Repeat | Other | Unclass | Total |
|---|---|---|---|---|---|---|
| Initial Violations | 1 | 1 | ||||
| Current Violations | 1 | 1 | ||||
| Initial Penalty | $0 | $0 | $0 | $450 | $0 | $450 |
| Current Penalty | $0 | $0 | $0 | $450 | $0 | $450 |
| FTA Penalty | $0 | $0 | $0 | $0 | $0 | $0 |
| # | Citation ID | Citaton Type | Standard Cited | Issuance Date | Abatement Due Date | Current Penalty | Initial Penalty | FTA Penalty | Contest | Latest Event | Note |
|---|---|---|---|---|---|---|---|---|---|---|---|
| 1. | 01001 | Other | 3203 A | 01/25/2005 | 02/25/2005 | $450 | $450 | $0 | - |
Investigation Summary
At approximately 8:00 a.m. on July 26, 2004, an employee worked in the metal fabrication department of K&N Engineering located in Riverside, CA. The employer manufactured after-market specialty automotive air filters. The employee cut specific length sections from a 10-foot length of 3.5 inch diameter aluminum tubing. He used a Ridgid 14 inch dry cut saw, Model 614, equipped with a carbide-tipped blade rated for cutting ferrous and non-ferrous metals. The employee attempted to trim less than an inch off the end of a 16-inch length of tubing without securing it in the vice clamp, which was built into the left side of the saw. Instead, the employee held the tubing against the right side fence with his right hand. During the cut, the blade jammed and caused the tube to twist. The employee's right hand was propelled toward the spinning blade and the tip of his right thumb was amputated just above the nail bed and just below the distal joint.
Keywords: AMPUTATED, UNSECURED, METAL SHOP, ROTATING KNIFE, WORK RULES, THUMB, JAMMED, METAL SAW, BLADE, METAL PIPE
| # | Inspection | Age | Sex | Degree of Injury | Nature of Injury | Occupation |
|---|---|---|---|---|---|---|
| 1 | 125885574 | Hospitalized injury | Amputation | Misc. metal,plastic,stone&glass-working mach. op's |