Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Inspection Detail

Inspection: 120120761 - Allied Signal Aerospace Company

Inspection Information - Office: Ca Long Beach District Office

Nr: 120120761Report ID: 0950635Open Date: 12/13/1994

Allied Signal Aerospace Company
2525 W 190th St
Torrance, CA 90504
Union Status: Union
SIC: 3721/Aircraft

Inspection Type:Accident
Scope:Partial Advanced Notice:N
Ownership:Private
Safety/Health:Safety Close Conference:01/03/1995
Planning Guide: Safety-Manufacturing Close Case:07/19/1995

Related Activity:TypeIDSafetyHealth
 Accident362021180    
 Accident362021461    

Violation Summary
Serious Willful Repeat Other Unclass Total
Initial Violations 2 1 3
Current Violations 2 1 3
Initial Penalty $10,000 $0 $0 $300 $0 $10,300
Current Penalty $10,000 $0 $0 $300 $0 $10,300
FTA Amount $0 $0 $0 $0 $0 $0

Violation Items
# ID Type Standard Issuance Abate Curr$ Init$ Fta$ Contest LastEvent
  1. 01001 Other 3203 A 01/04/1995 01/31/1995 $300 $300 $0 -
  2. 02001 Serious 3314 B 01/04/1995 01/18/1995 $5,000 $5,000 $0 -
  3. 03001 Serious 3328 G 01/04/1995 01/18/1995 $5,000 $5,000 $0 -

Accident Investigation Summary
Summary Nr: 170358998Event: 11/29/1994Employee'S Fingers Injured While Installing Faceplate
On November 29, 1994, Employee #1 was installing a faceplate on an Okuma engine lathe PCN007010097, serial #4308-13390, at a Torus and Scrolls shop. With the help of a skyhook, the faceplate was positioned on the right-hand side of the chuck. One of the three holes on the faceplate was aligned with one chuck hole, and one bolt was positioned and partially tightened. The other two bolts were yet to be positioned. According to the shop manager, the speed was set at 24 rpm. Suddenly the faceplate and the spindle started rotating counterclockwise. The hook on the skyhook chain was still attached to the faceplate and it pressed Employee #1's fingers, amputating his little finger and injuring two other fingers. Before starting the set-up, he did not press the OFF button of the engine control box or of the control panel next to the lathe machine. The handle of the spindle control lever near head stock (F6 per manual) had been removed by management a long time ago. Employee #1 could have pressed the socket where the F6 lever rested with his foot, causing spindle motion. The only other spindle control lever on the right-hand side (C-26 per manual) might have been somewhat loose due to wear and tear, causing the lever to shift slightly and the spindle to rotate.
Keywords: chain, lathe, amputated, finger, work rules, control lever, lockout, spindle, set up
Inspection Degree Nature Occupation
1 120120761 Hospitalized injury Amputation Fabricating machine operators, n.e.c.

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close