Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Inspection Detail

Inspection: 112902283 - Dana Corporation

Inspection Information - Office: Harrisburg

Nr: 112902283Report ID: 0316700Open Date: 09/06/2000

Dana Corporation
Robeson & Weiser Streets
Reading, PA 19612
Union Status: Union
SIC: 3711/Motor Vehicles and Passenger Car Bodies
Mailing: P.O. Box 13459, Reading, PA 19612

Inspection Type:Accident
Scope:Partial Advanced Notice:N
Safety/Health:Safety Close Conference:09/21/2000
Emphasis: S:AmputationsClose Case:11/06/2000

Related Activity:TypeIDSafetyHealth
 Complaint76965185 Yes  
 Complaint200564078 Yes  

Violation Summary
Serious Willful Repeat Other Unclass Total
Initial Violations 2 2
Current Violations 2 2
Initial Penalty $9,500 $0 $0 $0 $0 $9,500
Current Penalty $9,500 $0 $0 $0 $0 $9,500
FTA Amount $0 $0 $0 $0 $0 $0

Violation Items
# ID Type Standard Issuance Abate Curr$ Init$ Fta$ Contest LastEvent
  1. 01001 Serious 19100212 A01 10/18/2000 11/14/2000 $2,500 $2,500 $0 -
  2. 01002 Serious 19100212 A03 II 10/18/2000 11/14/2000 $7,000 $7,000 $0 -

Accident Investigation Summary
Summary Nr: 14318778Event: 09/05/2000Employee Killed When Head Crushed By Gantry Crane
At approximately 1:49 a.m. on September 5, 2000, Employee #1 was working on the K-1 fixture at the Ford line, the start of the frame assembly for a pickup truck. He was relieving a coworker who had been operating the fixture at the northeast corner, and he was one of four employees to operate this machine. The workers installed rivets and crossmembers at key locations in the frame. After each worker installed approximately four rivets, they would retreat to a palm button station at each corner of the machine. Each station incorporated two palm buttons and a red stop button; three of the four employees had to depress their buttons and hold them in while the fourth operator depressed his buttons and became the trigger man. When the fourth employee depressed his buttons, the circuit was closed and a gantry crane on a monorail was signaled to descend and grasp the steel frame with four claws and carry it to another position to be worked on. The area around the truck frame was partially protected by a light curtain that angled away from the frame table. After Employee #1's coworker returned to the K-1 fixture, he stepped up on to the work platform and put on his left glove first. The operator at the north-west corner immediately across from Employee #1 and his coworker had just finished putting in his rivets and was standing at his palm buttons. Employee #1 was installing his last rivet, which required him to bend over the frame at an angle and place his head in close proximity to the frame. At this time, the gantry crane descended, traveling at 36 in. per second and covering the 48 in. in 1.5 seconds. Employee #1's head was pinched against the steel frame by one of the lifting claws. The machine then became locked in position, continuing to push his head against the steel frame. The machine shut down because the light curtain was broken by coworkers reaching in to help Employee #1, and at the same time one of the operators depressed his emergency STOP button. Employee #1 died of crushing injuries to his head. At the time of the accident, another operator was working at the southeast corner to the left of Employee #1. He had just come back from getting a crossmember and was placing in on the ground getting ready for the next frame; he was not on his palm buttons when the gantry descended. The other operator was at the southwest corner, had finished his rivets, and was depressing and holding his buttons when the crane came down. Only one of the four palm button stations was depressed at the time of the accident, and the light curtain was showing green for go. Subsequent examination of the light curtain determined that there was a dead zone between the curtain and the frame of the machine. At the lowest level, 24 inches were not covered by the light curtain; at the hip area, the distance increased to 31 inches. Immediately following the accident, the company installed another light curtain that covered all the dead zones missed by the original curtain.
Keywords: head, hand control, work rules, gantry crane, caught between, crushed, light curtain, communication
Inspection Degree Nature Occupation
1 112902283 Fatality Fracture Assemblers

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.