Translate
Inspection Detail
Inspection: 1400277.015 - Caliber Mold And Machine
Inspection Information - Office: Cleveland Area Office
Site Address:
Caliber Mold And Machine
1461 Industrial Parkway
Akron, OH 44326
Mailing Address:
1461 Industrial Parkway, Akron, OH 44326
Union Status: NonUnion
SIC:
NAICS: 333511/Industrial Mold Manufacturing
Inspection Type: Referral
Scope: Partial
Advanced Notice: N
Ownership: Private
Safety/Health: Safety
Close Conference: 05/13/2019
Emphasis: N:Amputate
Case Closed: 04/06/2020
| Type | Activity Nr | Safety | Health |
|---|---|---|---|
| Referral | 1454025 | Yes |
| Violations/Penalties | Serious | Willful | Repeat | Other | Unclass | Total |
|---|---|---|---|---|---|---|
| Initial Violations | 1 | 1 | ||||
| Current Violations | 1 | 1 | ||||
| Initial Penalty | $5,304 | $0 | $0 | $0 | $0 | $5,304 |
| Current Penalty | $3,900 | $0 | $0 | $0 | $0 | $3,900 |
| FTA Penalty | $0 | $0 | $0 | $0 | $0 | $0 |
| # | Citation ID | Citaton Type | Standard Cited | Issuance Date | Abatement Due Date | Current Penalty | Initial Penalty | FTA Penalty | Contest | Latest Event | Note |
|---|---|---|---|---|---|---|---|---|---|---|---|
| 1. | 01001 | Serious | 19100147 D02 | 06/20/2019 | 09/30/2019 | $3,900 | $5,304 | $0 | I - Informal Settlement |
Investigation Summary
At 7:30 a.m. on May 8, 2019, an employee was working as a machinist for a firm that manufactured industrial molds. He was operating a vertical lathe. The lathe was a 60 inch (1.5 meter) Webster-Bennett vertical lathe boring mill, with serial number 5890-1. It ran approximately eight hours every day, and four to six days a week, depending on product demand. The lathe had a table that spun in operation. The table could operate at 3.8 to 83 revolutions per minute (rpm). On the day of the incident, the table was set to rotate at 25 rpm. The employee was setting up the jacks on the table to get a part ready to run. The center of table was full of metal chips. The employee cleaned the center of the table. The employee came out of the turntable area and turned the table on. There were still chips on the jack, causing the part not to sit flat on the table. The employee turned the table off again. He grabbed an air hose to blow the chips off the jack. The air hose hit the lever that turned the machine on. The table began to spin as the employee was reaching across the table to blow away the chips. The air hose and the employee's sleeve were caught by the table, and the employee was pulled into the machine. He suffered six broken ribs. He was hospitalized.
Keywords: Air Hose, Caught By, Cleaning, Clothing, Control Lever, Fracture, Jack, Lathe, Lockout, Machine Cycled, Machinist, Rib, Rotating Parts
| # | Inspection | Age | Sex | Degree of Injury | Nature of Injury | Occupation |
|---|---|---|---|---|---|---|
| 1 | 1400277.015 | 47 | M | Hospitalized injury | Machinists |