Powered by GoogleTranslate

Inspection Detail

Inspection: 126114800 - Uc Los Angeles

Inspection Information - Office: Los Angeles District Office

 

Inspection Nr: 126114800
Report ID: 0950641
Date Opened: 11/19/2001

Site Address:
Uc Los Angeles
Bunche Hall, Rm. 8263
Los Angeles, CA 90095

Mailing Address:
405 Hilgard Ave Rm 8263 Bunche Hall, Los Angeles, CA 90095

Union Status: NonUnion

SIC:8221

NAICS: 0 


Inspection Type: Accident

Scope: Partial

Advanced Notice: N

Ownership: StateGovt

Safety/Health: Safety

Close Conference: 12/10/2001

Emphasis:

Case Closed: 09/26/2008


Related Activity
Type Activity Nr Safety Health
Accident 362571341
Violation Summary
Violations/Penalties Serious Willful Repeat Other Unclass Total
Initial Violations 1 3 4
Current Violations 1 3 4
Initial Penalty $18,000 $0 $0 $840 $0 $18,840
Current Penalty $2,700 $0 $0 $840 $0 $3,540
FTA Penalty $0 $0 $0 $0 $0 $0

Violation Items
# Citation ID Citaton Type Standard Cited Issuance Date Abatement Due Date Current Penalty Initial Penalty FTA Penalty Contest Latest Event Note
1. 01001 Other 3203 A 01/08/2002 02/10/2002 $280 $280 $0 -  
2. 01002 Other 3314 F 01/08/2002 02/10/2002 $280 $280 $0 -  
3. 01003 Other 3314 H 01/08/2002 02/10/2002 $280 $280 $0 -  
4. 02001 Serious 4070 A 01/08/2002 01/18/2002 $2,700 $18,000 $0 04/22/2002 F - Formal Settlement  

Investigation Summary

Investigation Nr: 201162799
Event: 11/14/2001
Employee's finger amputated by fan blade

At approximately 8:00 a.m., on November 14, 2001, Employee # 1 responded to a bearing failure on air handling unit located in the fan room. The fan was making a very loud noise, indicating that the bearings needed to be replaced. Employee #1 determined that new parts were necessary and proceeds to obtain them. A coworker was instructed to assist Employee #1 with replacing the bearing on the unit. Employee #1 and the coworker started the repair work after lunch. The employees turned off the disconnect switch and fan start/stop switch. The fan and the motor were completely deenergized prior to beginning the repair work. The employees were equipped with leather gloves that were rubberized on the palm side. The repair work involved removing the belts and replacing the bearing component with a new one. Once the bearing component was replaced, the unit was re-assembled. The unit was energized to test/check the belt alignment and noise level of the fan. Once the test was completed, the unit was deenergized by turning off the disconnect switch. Employee #1 and the coworker exited the fan room and waited outside for the unit to stop before lubricating the new bearings. Employee #1 entered the fan room while the fan was still naturally coasting and stood adjacent to the drive sheave. Employee #1 attempted to slow down/stop the belt by placing his boot over the belts. While Employee #1 was standing hunched forward towards the motor, with his boot on the belt, the coworker, entered the fan room, asked Employee #1 a question, and handed him a cloth to help him stop the belts. As Employee #1 turned toward the coworker, his left hand made contact with the belts. Part of Employee #1 glove on his left hand was caught between the belts and pulley and pulled in towards the motor. Employee #1 attempted to pull his hand out, but was unable to do so, before his left middle fingertip from the first knuckle was amputated. Employee #1 was rushed to the emergency room, where the doctors made the determination that the amputated portion of his fingertip could not be reattached.

Keywords: FAN, REPAIR, FINGER, GLOVE, GUARD, BEARING, NOISE, PULLEY, BLADE, LUBRICATING

Investigated Inspection
# Inspection Age Sex Degree of Injury Nature of Injury Occupation
1 126114800 Hospitalized injury Amputation Occupation not reported
Back to Top

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close