Powered by GoogleTranslate

Inspection Detail

Inspection: 120172291 - Paul Graham Drilling & Service Co.

Inspection Information - Office: Redding District Office

 

Inspection Nr: 120172291
Report ID: 0950623
Date Opened: 04/15/1996

Site Address:
Paul Graham Drilling & Service Co.
Co. Road 9, 1/2 Mile East Of 6th Ave.
Orland, CA 95963

Mailing Address:
P.O. Box 669, Rio Vista, CA 94571

Union Status: NonUnion

SIC:1381

NAICS: 0 


Inspection Type: Accident

Scope: Complete

Advanced Notice: N

Ownership: Private

Safety/Health: Safety

Close Conference: 04/15/1996

Emphasis:

Case Closed: 11/08/1997


Related Activity
Type Activity Nr Safety Health
Accident 361666860
Violation Summary
Violations/Penalties Serious Willful Repeat Other Unclass Total
Initial Violations 1 1
Current Violations 1 1
Initial Penalty $4,000 $0 $0 $0 $0 $4,000
Current Penalty $0 $0 $0 $250 $0 $250
FTA Penalty $0 $0 $0 $0 $0 $0

Violation Items
# Citation ID Citation Type Standard Cited Issuance Date Abatement Due Date Current Penalty Initial Penalty FTA Penalty Contest Latest Event Note
1. 01001 Other 3203 A07 B 10/09/1996 10/16/1996 $250 $4,000 $0 10/17/1996 J - ALJ Decision  

Investigation Summary

Investigation Nr: 170360861
Event: 04/10/1996
Employee's arm injured when caught in gas well winch

At approximately 10:00 a.m. on April 10, 1996, Employee #1 was on the floor of the #4 Cooper 550 drilling rig. He and coworkers had pulled all the drill steel out of a natural gas exploratory well to change drill bits, and were preparing to begin running the drill pipe back into the hole. Employee #1 was getting ready to throw the spinning chain on the first section of pipe when he noticed the chain had bled out of the air winch and was hanging straight down below the floor. The winch would slowly bleed out the chain because the valve did not shut off properly. Employee #1 reached into the winch extension bar next to the winch to suck up the slack. He did not notice that the chain end was tied off. When the slack was pulled up, Employee #1's arm became caught in the chain loop and was pinched between the chain and the angle iron of the winch roller. He suffered torn muscles, ruptured veins, and a torn artery in his left arm just above the elbow that required surgery.

Keywords: DRILL OPERATOR, GAS WELL, CAUGHT BETWEEN, VALVE, ARM, ARTERY, GAS WELL DRILLING, WINCH, MECH MALFUNCTION

Investigated Inspection
# Inspection Age Sex Degree of Injury Nature of Injury Occupation
1 120172291 Hospitalized injury Cut/Laceration Construction laborers
Back to Top

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close