Inspection Detail
Inspection: 111922290 - Sierra Lumber Mfg
Inspection Information - Office: Modesto District Office
Site Address:
Sierra Lumber Mfg
375 W. Hazelton
Stockton, CA 95208
Mailing Address:
Po Box 6216, Stockton, CA 95206
Union Status: Union
SIC:5211
NAICS: 0
Inspection Type: Accident
Scope: Partial
Advanced Notice: N
Ownership: Private
Safety/Health: Safety
Close Conference: 10/07/1991
Emphasis:
Case Closed: 12/09/1991
| Type | Activity Nr | Safety | Health |
|---|---|---|---|
| Accident | 361338940 |
| Violations/Penalties | Serious | Willful | Repeat | Other | Unclass | Total |
|---|---|---|---|---|---|---|
| Initial Violations | 1 | 1 | ||||
| Current Violations | 1 | 1 | ||||
| Initial Penalty | $2,000 | $0 | $0 | $0 | $0 | $2,000 |
| Current Penalty | $2,000 | $0 | $0 | $0 | $0 | $2,000 |
| FTA Penalty | $0 | $0 | $0 | $0 | $0 | $0 |
| # | Citation ID | Citaton Type | Standard Cited | Issuance Date | Abatement Due Date | Current Penalty | Initial Penalty | FTA Penalty | Contest | Latest Event | Note |
|---|---|---|---|---|---|---|---|---|---|---|---|
| 1. | 01001 | Serious | 3314 A | 12/10/1991 | 09/27/1991 | $2,000 | $2,000 | $0 | - |
Investigation Summary
At or about 6:30 p.m. on September 18, 1991, Employee #1 was operating a finger joint machine. He noticed that the trimming was not aligned and had the machine shut off. Employee #1 adjusted the trim saw guide plate with a wrench. He then had the machine re-started so he could check the alignment. Rather than stop the machine again, Employee #1 attempted to tighten the bolts while the finger joint machine continued to run. He turned the wrench toward the moving board at the end of the transfer belt, and his hand slipped. His left thumb was caught and amputated below the thumbnail.
Keywords: AMPUTATED, SLIP, THUMB, LOCKOUT, SAW, HAND
| # | Inspection | Age | Sex | Degree of Injury | Nature of Injury | Occupation |
|---|---|---|---|---|---|---|
| 1 | 111922290 | Non Hospitalized injury | Amputation | Shaping and joining machine operators |
Translate