1
03/02/2010
- 1926.500, 1926.500(a)(2)(iii) -
Whether an employer can use a controlled access zone during curtain wall installation.
2
09/25/1995
- 1926.500 -
OSHA's new fall protection standards for construction will prohibit use of safety belts with side dee rings as part of a personal fall arrest system
3
12/05/2023 - 1926.500(b) - Suspended scaffold and fall protection requirements applicable to elevator construction
4
08/04/2016 - 1926.500(b)(1) - Fall protection requirements for a walking/working surface above a catch platform with a guardrail system
5
04/27/2015 - 1926.500(b) - Clarification of personal ladder boom system requirements
6
03/02/2010 - 1926.500(b) - Fall protection requirements for employees working on an elevator car frame.
7
03/02/2010 - 1926.500(a)(2)(iii) - Whether an employer can use a controlled access zone during curtain wall installation.
8
03/02/2010 - 1926.500(a)(1) - Interpretation of OSHA Fall Protection Exemption (29 CFR 1926.500(a)(1)) during inspection, investigation, and assessment activities.
9
08/14/2000
- 1926.500 -
Fall protection for various lift-devices; restraint, positioning, fall arrest and rescue requirements; maintenance vs. construction examples.
10
09/25/1995
- 1926.500 -
Review of a new product, "The Safety Boot".
11
03/02/2010
- 1926.500, 1926.500(a)(1) -
Interpretation of OSHA Fall Protection Exemption (29 CFR 1926.500(a)(1)) during inspection, investigation, and assessment activities.
12
03/16/2009 - 1926.500(b)(2) - Fall protection requirements for employees on construction equipment.
13
11/28/2007 - 1926.500(a)(2)(vii) - Whether OSHA requirements prohibit working from a portable stepladder and, if not, whether fall protection is required. 29 CFR 1926.1053(b).
14
09/05/2006 - 1926.500(b) - When protective measures must be installed after a hole is created on a construction worksite.
15
09/05/2006
- 1926.500, 1926.500(b) -
When protective measures must be installed after a hole is created on a construction worksite.
16
05/11/2005 - 1926.500(b) - Under Subpart M, whether a lanyard may be connected to another lanyard by a snaphook, provided the potential fall distance is six feet or less.
17
04/11/2005 - 1926.500(a)(2) - Scaffolding/shoring
18
04/11/2005
- 1926.500, 1926.500(a)(2) -
Scaffolding/shoring
19
09/30/2004 - 1926.500(b) - Clarification if a depression constitutes a hole or unprotected side/edge and associated fall protection requirements.
20
05/28/2004 - 1926.500(b) - The construction fall protection standard specifies fall arrest system requirements, but no footwear requirements.
21
03/12/2004 - 1926.500(a) - Fall protection during roofing inspections, investigations, and assessments
22
12/22/2003 - 1926.500(b) - Fall protection requirements for stairwells and mechanical chase openings surrounded by interior stud walls in residential construction
23
09/26/2003
- 1926.500 -
Compliance of using warning lines and/or control access zones for fall protection on roofs with a slope greater than 4:12.
24
07/07/2003 - 1926.500(a)(2)(i) - Requirements for fall protection when ladder jack scaffolds are used for residential and commercial construction
25
07/07/2003
- 1926.500, 1926.500(a)(2)(i) -
Requirements for fall protection when ladder jack scaffolds are used for residential and commercial construction
26
05/21/2003 - 1926.500(b) - Fall protection requirements for an employee working from a ladder on a walking/working surface other than the ground.
27
05/21/2003 - 1926.500(a)(2)(vii) - Fall protection requirements for an employee working from a ladder on a walking/working surface other than the ground.
28
05/21/2003
- 1926.500, 1926.500(a)(2)(vii), 1926.500(b) -
Fall protection requirements for an employee working from a ladder on a walking/working surface other than the ground.
29
11/15/2002
- 1926.500 -
Fall protection requirements for employees, other than roofers, working on low-slope roofs
30
05/11/2001 - 1926.500(b) - Standards applicable to aerial lifts; acceptable uses of body belts as restraint systems and positioning devices.
31
04/10/2001
- 1926.500 -
Requirements of Interim Fall Protection Compliance Guidelines for Residential Construction for guardrails and fall protection during roofing work.
32
08/14/2000
- 1926.500 -
Clarification of the terms "hole" versus "unprotected sides or edges."
33
05/12/2000
- 1926.500 -
Fall protection non-conforming guardrail criteria for application of a de minimis policy.
34
09/23/1999 - 1926.500(b) - Neither a waist nor chest strap is a required part of body harness.
35
11/17/1998 - 1926.500(b) - Clarification of fall protection requirements for open holes on a construction site.
36
10/24/1995 - 1926.500(a) - Fall protection for post-frame work.
37
09/25/1995
- 1926.500 -
OSHA's New Fall Protection Standard for the Construction Industry.
38
08/28/1995
- 1926.500 -
The frequency of the load measuring system when testing fall arrest equipment should be set at 500 Hz.
39
05/09/1995 - 1926.500(a) - Applicability of fall protection requirements/fall protection for waste collection and landfill activities.
40
03/24/1993
- 1926.500 -
Request for approval of guardrail system.
41
10/01/1991
- 1926.500 -
Stairways used in construction.
42
09/18/1984
- 1926.500 -
Ball-type handrail system.
43
07/24/1984
- 1926.500 -
Wire rope and/or cable as a method of perimeter protection for a building under construction.
44
04/14/1981
- 1926.500 -
Perimeter guarding of low-pitched roofs.
45
01/09/1979
- 1926.500 -
Steel Banding as Guardrails.
46
03/22/1978
- 1926.500 -
Requirements for toeboards.
47
10/21/1974
- 1926.500 -
Use of stilts.