# Standard Interpretations
1 - 1910.23 - Inspection Guidance for Inpatient Healthcare Settings
2 - 1910.23 - Guarding of Ladderway Floor Openings
3 - 1910.23 - Clarification of OSHA requirements pertaining to winding stairway systems.
4 - 1910.23 - Guarding of Access Openings to Fixed Ladders.
5 - 1910.23 - Compliance of stair and platform railings with height requirements in OSHA standards for fixed industrial stairs.
6 - 1910.23 - Guarding requirements for skylights and "grandfather" provisions for buildings constructed over twenty years ago.
7 - 1910.23 - Alternative fall protection program when guardrails are infeasible to install.
8 - 1910.23 - Acceptability of slip on fittings on stair rails and requirement for stair rails to be smooth surfaced.
9 - 1910.23 - Acceptability of a fixed ramp with a one-in-four slope on an industrial conveyor.
10 - 1910.23 - Ladder safety requirements for towers more than 20 feet in length: sliding fall protection devices, safety cages/wells, landing platform intervals.
11 - 1910.23 - Additional fall protection requirements for concrete trucks when work platforms are equipped with guardrails and toeboards.
12 - 1910.23 - OSHA Guidance concerning use of clip on products for ladders to facilitate transport of the ladder or other objects.
13 - 1910.23 - Open roof hatches should be protected; grab bars not required at hatch exits.
14 - 1910.23 - OSHA requires fall protection for elevator work when a fall hazard is present.
15 - 1910.23 - General Industry Standard as it applies to the electric utility industry.
16 - 1910.23 - Fall Protection requirements in the Construction Standard.
17 - 1910.23 - Spacing requirements between two handrails.
18 - 1910.23 - Use of toeboards to protect a floor hole and variations in riser heights for stairs.
19 - 1910.23 - Conveyor Crossover Stile.
20 - 1910.23 - OSHA's requirements for locking type snaphooks on pole strap systems
21 - 1910.23 - Ramps: guarding and means of access to a higher elevation.
22 - 1910.23 - Interpretation Regarding Guardrails Proposed for Coors Stadium.
23 - 1910.23 - Toeboard requirements on walkways over interior of a water tank.
24 - 1910.23 - Platforms and ladders on communication towers.
25 - 1910.23 - Toe clearances on ladders.
26 - 1910.23 - Nominal vertical height requirement for toe boards.
27 - 1910.23 - Ladderway floor openings.
28 - 1910.23 - Fall protection for employees exposed to hazardous falls from roofs.
29 - 1910.23 - Safeguarding of floor holes between platforms and equipment.
30 - 1910.23 - Clarification of our railing requirements in 29 CFR 1910.23(e).
31 - 1910.23 - Clarification of 1910.23 as it would apply to repair pits.
32 - 1910.23 - The use of a safety chain in lieu of a gate.
33 - 1910.23 - Tip-up rigid guardrail system.
34 - 1910.23 - Proposed Powered Platform installations.
35 - 1910.23 - The positioning of the safety line on billboards.
36 - 1910.23 - The enforcement of 29 CFR 1910.23(a)(9), for floor openings and holes.
37 - 1910.23 - Sectionalized rail systems.
38 - 1910.23 - Clarification of 1910.23(c)(1).
39 - 1910.23 - Loading docks.
40 - 1910.23(a)(1) - Guarding requirements for skylights.
41 - 1910.23(e)(8) - Guarding requirements for skylights.
42 - 1910.23(a)(1) - Personal Fall Arrest System or Ladder Safety System on Fixed Ladders, and Fixed Ladders Used on Grain Silos for Emergency Escape
43 - 1910.23(a)(2) - A swinging gate is required only at ladderway floor openings and platforms.
44 - 1910.23(a)(2) - Fall protection requirements when working from ladders in the telecommunications industry
45 - 1910.23(c)(1) - Fall protection requirements when working from ladders in the telecommunications industry
46 - 1910.23(c)(3) - Fall protection requirements when working from ladders in the telecommunications industry
47 - 1910.23(a)(2) - Guarding of Access Openings to Fixed Ladders.
48 - 1910.23(b) - Clarification of protection of wall openings and holes.
49 - 1910.23(b)(12) - Ladder Grasp Requirements
50 - 1910.23(b)(12) - Fall Protection Requirements for Fixed Ladders
51 - 1910.23(b)(13) - Fall Protection Requirements for Fixed Ladders
52 - 1910.23(c) - Fall protection for an extendable gangway.
53 - 1910.23(c) - Alternative fall protection program when guardrails are infeasible to install.
54 - 1910.23(c)(1) - A tie-off system is acceptable where a standard guardrails are not feasible
55 - 1910.23(c)(1) - Guardrail and toeboard requirements for antenna platforms.
56 - 1910.23(a)(6) - The acceptability of manhole entries through concentric cone or eccentric cone concrete pipe transition sections to underground workplaces.
57 - 1910.23(c)(1) - The acceptability of manhole entries through concentric cone or eccentric cone concrete pipe transition sections to underground workplaces.
58 - 1910.23(c)(1) - Additional fall protection requirements for concrete trucks when work platforms are equipped with guardrails and toeboards.
59 - 1910.23(e)(1) - Whether additional handrails are required on the grated walkways provided on one side of the 13 belt conveyors.
60 - 1910.23(c)(2) - Whether additional handrails are required on the grated walkways provided on one side of the 13 belt conveyors.
61 - 1910.23(c)(3) - Interpretation on requirements for guard rail height on ledges.
62 - 1910.23(c)(3) - Workers must be protected from hazards of heated (hot) surfaces.
63 - 1910.23(d) - Stairways for public use are not covered by OSHA.
64 - 1910.23(d)(1) - Clarification of OSHA requirements pertaining to winding stairway systems.
65 - 1910.23(e)(1) - Clarification of OSHA requirements pertaining to winding stairway systems.
66 - 1910.23(e)(2) - Clarification of OSHA requirements pertaining to winding stairway systems.
67 - 1910.23(e) - Handrail and railing specifications for general industry.
68 - 1910.23(e) - Compliance of stair and platform railings with height requirements in OSHA standards for fixed industrial stairs.
69 - 1910.23(e)(1) - Top rail and handrail requirements for stairrail systems under the construction standards.
70 - 1910.23(e)(1) - Conditions under which a stair railing can also serve as a handrail.
71 - 1910.23(e)(2) - Conditions under which a stair railing can also serve as a handrail.
72 - 1910.23(e)(5)(ii) - Conditions under which a stair railing can also serve as a handrail.
73 - 1910.23(e)(1) - Acceptability of slip on fittings on stair rails and requirement for stair rails to be smooth surfaced.
74 - 1910.23(e)(2) - Clarification of apparent discrepancy in height requirements for stair and hand railings.
75 - 1910.23(e)(2) - Stair rail height must be between 30-34 inches.
76 - 1910.23(e)(3) - Spacing of the posts in between modular guardrail system sections.
77 - 1910.23(e)(3) - Requirements for Guardrail systems
78 - 1910.23(e)(3)(v) - Requirements for Guardrail systems
79 - 1910.23(e)(3)(ii) - The diameter of standard pipe railings.
80 - 1910.23(e)(3)(iv) - Clarification of the 200 pounds strength requirement for railings.
81 - 1910.23(e)(3)(v) - Clarification of the 200 pounds strength requirement for railings.
82 - 1910.23(a)(3) - Hatch Net 120 fall protection system
83 - 1910.23(a)(8) - Hatch Net 120 fall protection system
84 - 1910.23(a)(4) - Guarding requirements for skylights and "grandfather" provisions for buildings constructed over twenty years ago.
85 - 1910.23(a)(5) - Bay Nets Safety System.
86 - 1910.23(a)(5) - Grain handlers and engulfment hazards; procedures for unguarded sweep augers.
87 - 1910.23(a)(8) - Permanent handrail on platform inside a chimney or silo
88 - 1910.23(a)(9) - Clarification of 1910.23(a)(9) as it applies to fixed ladders and platforms.
89 - 1910.23(c)(14) - Portable ladders.
90 - 1910.23(d)(1)(v) - Center stair rail requirements for fixed industrial stairs greater than 88 inches wide.
91 - 1910.23(e)(3)(v) - Perimeter protection at setback roof levels.
92 - 1910.23(e)(5)(iii) - Provisions for mounting lighting on guardrails.
93 - 1910.23(e)(6) - Handrail and railing clearance for runways (hangar catwalks).