Application of steel erection standards to precast concrete and lift slab structures.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

July 2, 2002

Mr. Joe Bratcher
H B Training and Consulting
84-A Jopenea Boulevard
Hoschton, GA 30548

Re: Subpart Q; §1926.750(a); tilt-up concrete construction; lift-slab

Dear Mr. Bratcher:

Application of CPL 2-1.29, Interim Inspection Procedures during Communication Tower Construction Activities.

Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

April 25, 2001

Sheldon J. Gross
Manager, FAA Eastern Region
ANI 200
One Aviation Plaza Jamaica, New York 11434

Re: §1926.550(g)(2); §1926.753(a)(4); towers, personnel hoists; hoisting.

Dear Mr. Gross:

Tie off of iron workers while performing connector operations is not always required.

Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

 

 

Fall protection during steel erection and the application to the construction industry.

Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

September 18, 1992

Mr. Mark W. Monson
Manager of Projects
Chicagoland Construction
Safety Council
4415 West Harrison Street,
Suite 403
Hillside, Illinois 60162

Dear Mr. Monson:

Decision to release the new compliance directive for the steel erection standard in draft form.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

December 21, 2001

Mr. Stephen E. Sandherr
Chief Executive Officer
The Associated General Contractors of America
333 John Carlyle Street
Suite 200
Alexandria, VA 22314

Dear Mr. Sandherr:

History and background of the Steel Erection Final Rule.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

September 27, 2001

Mr. Eric Newton
Steel Supply & Erection Co., Inc.
1237 N. Fayetteville Street
Asheboro, NC 27204

Dear Mr. Newton:

This is in response to your letter of April 24 to Senator John Edwards regarding concerns about the cost of the Occupational Safety and Health Administration's (OSHA's) new steelerection standard. Your letter was forwarded to OSHA for response.

Sheer connector requirements in the steel erection standard to bridge repair/rehabilitation.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

January 23, 2003

Mr. John J. Robinson, Jr.
Assistant Chief Counsel
Commonwealth of Pennsylvania
Department of Transportation
Office of the Chief Counsel
P.O. Box 8212
Harrisburg, Pennsylvania 17105-8212

Re:  Whether the steel erection standard requires shear connectors to be removed during bridge repair work; §§1926.750, 1926.754(c)(1)

Dear Mr. Robinson:

Use of fall protection by deaf employees performing steel erection activities.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

 

Planking shall be 2 inch full size undressed.

Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

November 12, 1976

Mr. Tom Wagner
Safety Administration
Wisconsin Bridge & Iron Co.
5023 North 35th Street
Milwaukee, Wisconsin 53209

Subject: 1926.750(b)(2) Flooring Requirements

Reference: Your letter of October 26, 1976, to Mr. Florzak of our Milwaukee Office

Dear Mr. Wagner:

Fall Protection in Steel Erection.

Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at https://www.osha.gov.

 

 

July 10, 1995