US Dept of Labor

Occupational Safety & Health AdministrationWe Can Help

Standard Interpretations - Table of Contents
• Standard Number: 1910.179

September 26, 1996

Mr. John R. Molovich
United Steelworkers of America
Five Gateway Center
Pittsburgh, PA 15222

Dear Mr. Molovich:

This is in response to your September 19 request for interpretation of the overhead and gantry cranes standard, 29 CFR 1910.179. The scenario described in you letter, your question and our reply follow.

Scenario: A steel plant has two four hundred and fifty ton overhead cranes. Both of these cranes are operated at near capacity while handling molten metal. The following test was performed. One of the cranes was operated to lift an empty ladle some 15 feet off the floor. The crane operator placed the hoist controller in the first contact point in the lowering position. Then the crane operator pulled the main power switch (located in the cab)removing power from the hoist control circuit. The downward motion of the ladle did not stop until the crane operator moved the hoist controller to the neutral, center position. The aforementioned test and the result was communicated to company officials who advised, based on controller manufacturer information, that the controller would have to be placed in the neutral, center position to stop the downward movement of the ladle upon loss of power.

Question: Does the overhead crane described in the preceding scenario meet the holding brake requirement of paragraph 1910.179(f)(2)(iii)?

Reply: If the crane is equipped with holding brakes which are not designed to be applied automatically, the employer would be in violation of paragraph 1910.179 (f)(2)(iii). If the crane is equipped with holding brakes which are designed to be applied automatically when the power is removed and does not do so and the crane is continued in service without adjustment or repairs, the employer would be in violation of paragraph 1910.179(l)(3).

Thank you for your interest in employee safety and health. If we can be of further assistance, please contact the Office of Safety Compliance Assistance, Mr. Ronald J. Davies, telephone (202) 219-8031, extension 110.


Michael G. Connors
Deputy Assistant Secretary

Standard Interpretations - Table of Contents

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.