Standard Cited: 5A0001 OSH Act General Duty Paragraph
This violation item has been deleted.
|Nr: 18252858||Citation: 03006||Issuance: 11/02/1989||ReportingID: 0317900|
|Viol Type:||Serious||NrInstances:||1||Contest Date:||11/24/1989|
|Abatement Date:||12/02/1989||Nr Exposed:||900||Final Order:||02/11/1991|
|Current Penalty:||$800.00||Gravity:||08||Haz Category:||CRUSHING|
|Penalty and Failure to Abate Event History|
|Penalty||F: Formal Settlement||02/11/1991||$800.00||12/02/1989||Serious|
Text For Citation: 03 Item/Group: 006 Hazard: CRUSHING
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to death or crushing hazards from falling loads caused an improper combination of equipment: a) Sheet and Tin Division 1) Tin Free Steel Entry Tower, North Side - A 3/4 inch sheave was placed in service where 7/8 inch wire rope was used thus imposing excessive strain and abrasive wear on the wire rope, observed August 10, 1989. A feasible and acceptable abatement method to correct the hazard is to replace the improperly used sheave with an appropriate one.
The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.