Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Violation Detail

Standard Cited:5A0001 OSH Act General Duty Paragraph

Violation Items

Nr: 1428503.015 Citation: 01001 Issuance: 01/16/2020 ReportingID: 0729700

Viol Type:Other NrInstances:1 Contest Date:
Abatement Date:03/31/2020 2 Nr Exposed:3 Final Order:02/06/2020
Initial Penalty: $13,494.00 REC:A Emphasis:
Current Penalty: $9,445.80 Gravity: Haz Category:

Penalty and Failure to Abate Event History
Type Event Date Penalty Abatement Type FTA Insp
Penalty Z: Issued 01/16/2020 $13,494.00 02/03/2020 Serious  
Penalty I: Informal Settlement 02/06/2020 $9,445.80 03/31/2020 Other  

Text For Citation: 01 Item/Group: 001 Hazard:

OSH ACT of 1970 Section (5)(a)(1): OSH ACT of 1970 SECTION (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to struck by hazards: The employer is failing to protect employees from struck-by hazards. This was most recently documented on or about September 4, 2019, at 3012 S. 24th street in Kansas city, KS. Employee(s) were exposed to struck-by hazards while setting up a shaft piece to the lathe chuck in order to polish the finish piece. The employer had not developed and implemented procedures to ensure the manual three jaw lathe chuck was operated and maintained in accordance with the manufacturers instructions. Acceptable means of abatement include but are not limited to: a) Follow manufacturer's procedures for operating, maintaining, lubricating and cleaning of the lathe chuck. b) Ensure that the operators have receive training; according to the chuck manufacture recommendations for operating, maintaining, lubricating and cleaning; before being allowed to operation the lathe chuck. c) Use the lubricant recommended in the operating instructions. d) Do not use compressed air to clean the chuck, as recommended by the manufacture. e) Use a load cell to check gripping force at regular intervals as recommended by the manufacture.

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close