Text For Citation: 01 Item/Group: 001A Hazard:

29 CFR 1926.304(f) Section 4.1.2(b) American National Standards Institute 01.1-1961, Safety Code for Woodworking Machinery as adopted by 29 CFR 1926.304(f): Circular hand-fed rip saws were not equipped with a spreader to prevent material from squeezing the saw or being thrown back on the operator: 29 CFR 1926.304(f) Section 4.1.2(c) American National Standards Institute 01.1-1961, Safety Code for Woodworking Machinery as adopted by 29 CFR 1926.304(f): Circular hand-fed rip saws did not have non-kickback fingers or dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator: 29 CFR 1926.304(f) Section 5.1.3.3 American National Standards Institute 01.1-1975, Safety Code for Woodworking Machinery as adopted by 29 CFR 1926.304(f): Electrically driven equipment was not equipped with magnetic switches or other devices that will prevent automatic restarting of the machine after a power failure: a) First floor, on or about 5-19-14: Employees were ripping framing lumber on a table saw that was not equipped with a spreader. b) First floor, on or about 5-19-14: Employees were ripping framing lumber on a table saw that was not equipped with non kick-back fingers or "dogs". c) First floor, on or about 5-19-14: Employees were ripping framing lumber on a table saw that was not equipped with a magnetic switch or anti-restart device.