Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Inspection Detail

Inspection: 310026265 - S & W Tower Maintenance, Inc.

Inspection Information - Office: Jacksonville

Nr: 310026265Report ID: 0419700Open Date: 06/26/2006

S & W Tower Maintenance, Inc.
Highway 177a, 7 Miles North Of Us79
Bethlehem, FL 32425
Union Status: NonUnion
SIC: 1731/Electrical Work
NAICS: 238210/Electrical Contractors
Mailing: 2820 Rheinhardt, Evansville, IN 47714

Inspection Type:Accident
Scope:Complete Advanced Notice:N
Ownership:Private
Safety/Health:Safety Close Conference:09/14/2006
Emphasis: L:FallClose Case:10/31/2007

Related Activity:TypeIDSafetyHealth
 Accident101355550    

Violation Summary
Serious Willful Repeat Other Unclass Total
Initial Violations 2 2
Current Violations 2 2
Initial Penalty $9,800 $0 $0 $0 $0 $9,800
Current Penalty $2,500 $0 $0 $0 $0 $2,500
FTA Amount $0 $0 $0 $0 $0 $0

Violation Items
# ID Type Standard Issuance Abate Curr$ Init$ Fta$ Contest LastEvent
  1. 01001 Serious 5A0001 10/13/2006 11/16/2006 $1,250 $4,900 $0 11/01/2006 F - Formal Settlement
  2. 01002 Serious 19260502 E05 10/13/2006 10/25/2006 $1,250 $4,900 $0 11/01/2006 F - Formal Settlement

Accident Investigation Summary
Summary Nr: 201353141Event: 06/25/2006Employee Killed In Fall From Hoist Line On Communication Tow
On June 25, 2006, Employee #1 was part of a crew that was removing antenna equipment from a 1,900-ft communication tower for placement on another tower. One of the workers was on the ground operating the Hydraulic Power Systems, Inc., hoisting unit. Two workers were at a height of approximately 1,800 ft on the tower, removing the equipment. Once it was free, they would connect it to a 5/8-in. nylon rope, and the hoist operator would lower it to about the 600 ft level of the tower, where Employee #1 was located. He was connected to and suspended by a 1/2 in. wire rope hoist line. Once the equipment reached him, he would connect it to the hoist line, and the hoist operator would then lower him and the equipment to the ground. Employee #1 would disconnect the equipment, and then be raised back up to wait for the next load. During the course of the operations, Employee #1 was being raised when the nylon rope broke. The approximately 100 lb equipment attached to the rope fell from approximately 1,800 ft, as did a headache ball that was also attached to the rope. The broken end of the rope became tangled on the rigging block that was on top of the tower. This caused the nylon rope to suddenly stop, and the shock caused the it to break again at a point just above the headache ball. The nylon rope, headache ball, and equipment fell until they struck Employee #1 on the hoist line. He was connected to the line with a CM chain repair link that was not designed to be part of a personal fall protection or positioning system. The link separated and Employee #1 fell about 550 ft to the ground. He was killed. Subsequent investigation revealed several problems with the hoisting system: the rigging, hoist line, and slings that were used to raise personnel had not been installed with a 10:1 safety factor; Employee #1 was on the hoist line while another load was suspended from the same hoist unit; Employee #1 connected his fall protection/positioning device to a shackle above the hook rather than using a lanyard that had been placed directly on the hook; and no anti-two-blocking device was installed on the personnel hoisting line. It was believed that the nylon rope was cut by the wire rope where they both passed through the same double-block rigging device at approximately 500 ft on the tower.
Keywords: communication tower, hoisting mechanism, rope, work rules, broken cable, construction, fall, fall protection, struck by, hoistline
Inspection Degree Nature Occupation
1 310026265 Fatality Fracture Occupation not reported

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close