Text For Citation: 02 Item/Group: 001 Hazard:

29 CFR 1910.147(d): Application of control. The established procedures for the application of energy control (the lockout or tagout procedures) shall cover the following elements and actions and shall be done in the following sequence: Employees who perform servicing and maintenance on the 155 Panel Line machine during cleaning of cardboard scrap on the compression deck idler and roller were not required to: (1) know the type and magnitude of the energy sources, 480 Volt AC electrical energy source and 80 p.s.i. pneumatic energy source, the hazards of the energy sources to be controlled, and the method or means to control the energy, (2) turn off and shut down the compression deck (3) physically locate and operate energy isolating devices in such a manner as to isolate the machine from the energy source (4) affix lockout device to the energy isolating device (5) prior to starting work on machines that have been locked out, verify that isolation and deenergization of the machine had been accomplished Employees were exposed to an in-running nip point hazard while cleaning the idler and roller on the compression deck of cardboard scrap. Honey Cell Inc. Midwest was previously cited for a violation of this occupational safety and health standard or its equivalent standard, which was contained in OSHA inspection number 110718, citation number 1, item number 1b and was affirmed as a final order on March 27, 2013, with respect to a workplace located at 6480 Hamilton Lebanon Road, Middletown, OH 45044.