Dci, Inc. | Occupational Safety and Health Administration osha.gov

Violation Detail

Standard Cited: 19100303 F02 General.

Inspection Nr: 1366023.015

Citation: 01017

Citation Type: Serious

Abatement Date: 05/20/2019 2

Initial Penalty: $8,525.00

Current Penalty: $4,000.00

Issuance Date: 04/03/2019

Nr Instances: 18

Nr Exposed: 100

Related Event Code (REC):

Gravity: 5

Report ID: 0111700

Contest Date: 04/23/2019

Final Order: 04/27/2022

Emphasis:

**Penalty and Failure to Abate Event History**
Type	Latest Event	Event Date	Penalty	Abatement Due Date	Citation Type
Penalty	F: Formal Settlement	04/27/2022	$4,000.00	05/20/2019	Serious
Penalty	C: Contested	04/26/2019	$8,525.00	05/20/2019	Serious
Penalty	Z: Issued	04/03/2019	$8,525.00	05/20/2019	Serious

Text For Citation: 01 Item/Group: 017 Hazard:

29 CFR 1910.303(f)(2): Each service, feeder, and branch circuit, at its disconnecting means or overcurrent device, was not legibly marked to indicate its purpose, nor located and arranged so the purpose was evident: Rough Mill, Milling, Plywood Area- Employees operating woodworking equipment were not protected from electrical hazards where overcurrent devices, electric disconnects, and panel boards were not marked or legibly marked to indicate its purpose. The following equipment was not legibly marked to indicate its purpose: 1. Electric disconnect for the MJM Gang Saw 2. Electric disconnect for the feed conveyor after the MJM Gang Saw 3. Electric disconnect for the Dimter saw feed conveyor 4. Electric disconnect and control panel for the hammer mill 5. Circuit breakers in the 220 Volt panel board in the rough mill at the end wall by the exit 6. Electric disconnect for the Electro-Flow RF glue machine 7. Circuit breakers in the 480 Service Disconnect #2 panel board in the mill 8. Circuit breakers in two 480 volt panel boards near the Koch bore and dowel machine 9. Two 600 Volt electric disconnects near the Koch bore and dowel machine 10. Circuit breakers in the 208 volt panel board near the panel saws 11. All the Square D Plug-In Tap Boxes along the busways in the Rough Mill, Mill, and Plywood Area 12. Electric disconnect outside compressor room 13. 480 volt electric disconnects in the compressor room 14. Circuit breakers in the 480 volt panel board in the shipping department near the exit 15. Circuit breakers in the 220 volt panel board in the shipping department near the exit 16. 480 volt electric disconnects mounted on the wall outside the maintenance shop 17. Circuit breakers in the 480 volt PP-1 panel board in the maintenance garage 18. 480 volt electric disconnects in the maintenance garage near the finger joiner

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.