Text For Citation: 01 Item/Group: 015 Hazard:

29 CFR 1910.212(a)(3)(ii): Point(s) of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle(s): a) Bldg. 48-3, on or about 9/27/18: Point of operation on a LaPoint horizontal broach machine #31222 was not adequately guarded in that the slide guard provided did not prevent entry into the danger zone during the operating cycle. b) Bldg. 48-3, on or about 10/3/18: Point of operation on an Ohio horizontal broach machine #35811 was not adequately guarded in that the slide guard provided did not prevent entry into the danger zone during the operating cycle. c) Bldg. 76-3, on or about 10/5/18: Point of operation on an Alpha press #41224 was not adequately guarded in that there was an approximate 7 inch wide open on the left side of the guard and an approximate 4 1/2 inch opening on the right side of the guard. d) Bldg. 76-1, on or about 10/5/18: Point of operation on a Wagner cutoff saw #34593 was not adequately guarded in that the guard was not secured in place and you could reach into the left side of the saw. e) Bldg. 72-1, on or about 10/5/18: Point of operation on a Rhobi cutoff saw #075009 was not guarded on the right side. f) Bldg. 60-1, on or about 10/11/18: Point of operation was not guarded at the weld stations on two Burgmaster drill/mill/weld machines #33661 and #33748 and on a Rem Special #29089. g) Bldg. 57-1, on or about 10/12/18: Point of operation on the GFM machine #39816 was not guarded. h) Bldg. 46-1, on or about 10/12/18: Point of operation on an Ohio Broach #42099 was not adequately guarded in that the slide guard did not prevent entry into the danger zone during the operating cycle. i) Bldg. 48-3, on or about 10/23/18: Point of operation on a Cincinnati milling machine #31795 was not adequately guarded in that employees were exposed to the moving table/fixture and cutting tool at the milling head. j) Bldg. 48-3, on or about 10/23/18: Point of operation on a Cincinnati milling machine #30780 was not adequately guarded in that employees were exposed to the moving table/fixture and cutting tool at the milling head. k) Bldg. 48-3, on or about 9/27/18: Point of operation on an Ohio horizontal broach machine #41096 was not adequately guarded in that the slide guard provided did not prevent entry into the danger zone during the operating cycle. l) Bldg. 46-3, on or about 10/24/18: Point of operations at the cutting blades on two Rem Special trigger mills #28618 and #30245 were not guarded.