Translate
Violation Detail
Standard Cited: 19100305 G02 III Wiring methods, components, and equipment for general use.
Inspection Nr: 995311.015
Citation: 01011
Citation Type: Serious
Abatement Status: Corrected During Inspection
Initial Penalty: $4,250.00
Current Penalty: $7,000.00
Issuance Date: 03/04/2015
Nr Instances: 1
Nr Exposed: 2
Abatement Date:
Gravity: 5
Report ID: 0729300
Contest Date: 03/24/2015
Final Order: 08/26/2015
Related Event Code (REC): A
Emphasis:
| Type | Latest Event | Event Date | Penalty | Abatement Due Date | Citation Type | Failure to Abate Inspection |
|---|---|---|---|---|---|---|
| Penalty | J: ALJ Decision | 08/26/2015 | $7,000.00 | Serious | ||
| Penalty | J: ALJ Decision | 08/26/2015 | $0.00 | 03/25/2015 | Serious | |
| Penalty | C: Contested | 03/25/2015 | $4,250.00 | Serious | ||
| Penalty | C: Contested | 03/25/2015 | $5,000.00 | 03/25/2015 | Serious | |
| Penalty | Z: Issued | 03/04/2015 | $5,000.00 | 03/25/2015 | Serious | |
| Penalty | Z: Issued | 03/04/2015 | $4,250.00 | Serious |
Text For Citation: 01 Item/Group: 011 Hazard:
29 CFR 1910.333(c)(10): An interlock system was not returned to its operable condition when the work was completed: a. At cell 3, a key controlled interlock switch on the electrical control panel to the turret was frozen in the "off" (non-safe) position. Abatement certification and abatement documentation is required for this violation. The documentation should include written verification of abatement, applicable measurements or monitoring results, and photographs or videos which you believe will be helpful. The abatement certification sheet is enclosed with the citation(s). 29 CFR 1910.305(g)(2)(iii): Flexible cords and cables were not connected to devices and fittings so that strain relief was provided that would prevent pull from being directly transmitted to joints or terminal screws: a. In shipping area, the electrical plugs (connectors) to Hobart EZ Charge forklift chargers (Unit 10 & 12) were used and were not connected to devices and fittings so that strain relief was provided that would prevent pull from being directly transmitted to joints or terminal screws.