Text For Citation: 01 Item/Group: 010 Hazard:

29 CFR 1910.213(a)(9): All belts, pulleys, gears, shafts, and moving parts were not guarded in accordance with the specific requires of 1910.219: a) The Rosser head waste conveyor guard was damaged and did not protect ingoing nip for chain and sprocket in the yard. b) The Craftsman 12" band saw did not have a guard on the belt and pulley drive. c) The Rosser conveyor tail pulley section had an unguarded chain and sprocket drive. d) The peeling de barker tree drive shaft was exposed where the guard was out of position. e) The de barker in the addition did not have belts and pulleys guarded or area protected during operation. f) The shaker conveyor ingoing nip point was not guarded at platform level. g) The core conveyor outside of building had an unguarded 2" diameter shaft sticking out 5". h) The chipper needed additional guarding for the chain and sprocket drive. I) The conveyor feeding the chipper had an unguarded 1 1/2" shaft that was sticking out 2 1/2". j) The conveyor belt feeding the chipper had an unguarded ingoing nip point approximately 3" from the frame. k) The new core conveyor had an unguarded chain and sprocket at floor level. l) In the saw mill, shredder conveyor tail pulley guard was damaged and out of place. m) The overspill conveyor for the shredder belt needs to be guarded which is approximately 6' 2" off the floor to nip point. n) The 2nd barn cleaner from the de barker tail pulley needs guarding approximately 43" off the floor. o) The short side 2nd saw dust belt and pulley need guarding 82" off the floor. P) The chipper injector chain and sprocket drive unit needs to be fully guarded.