Translate
Violation Detail
Standard Cited: 19100219 C04 I Mechanical power-transmission apparatus.
Inspection Nr: 941008.015
Citation: 01007
Citation Type: Serious
Abatement Date: 09/02/2014 2
Initial Penalty: $5,500.00
Current Penalty: $3,675.00
Issuance Date: 03/03/2014
Nr Instances: 2
Nr Exposed: 14
Related Event Code (REC): C
Gravity: 5
Report ID: 0522500
Contest Date: 03/26/2014
Final Order: 08/21/2014
Emphasis:
| Type | Latest Event | Event Date | Penalty | Abatement Due Date | Citation Type | Failure to Abate Inspection |
|---|---|---|---|---|---|---|
| Penalty | F: Formal Settlement | 08/21/2014 | $3,675.00 | 09/02/2014 | Serious | |
| Penalty | C: Contested | 03/31/2014 | $5,500.00 | 03/20/2014 | Serious | |
| Penalty | Z: Issued | 03/03/2014 | $5,500.00 | 03/20/2014 | Serious |
Text For Citation: 01 Item/Group: 007 Hazard:
29 CFR 1910.219(c)(4)(i): Projecting shaft ends shall present a smooth edge and end and shall not project more than one-half the diameter of the shaft unless guarded by nonrotating caps or safety sleeves. a. On the sixth floor of the mill, Airlock Bench #4 M609, had a rotating shaft end that was not fully guarded to prevent accidental contact. The diameter of the shaft was approximately 1-1/4 inch in diameter and protruded approximately 3 inches from the equipment. b. In the mill basement, the feed loadout airlock motor F032, had a rotating shaft end that was not fully guarded to prevent accidental contact. The diameter of the shaft was approximately 1-1/4 inch in diameter and protruded approximately 3 inches from the equipment.