Text For Citation: 01 Item/Group: 005 Hazard:

29 CFR 1910.147(d): The established procedure for the application of energy control (the lockout or tagout procedures) did not cover the actions listed in and was not done in sequence as required by 29 CFR 1910.147(d)(1)-(6): (1) prepare for shutdown, (2) shut down machine or equipment, (3) physically locate and operate energy isolating devices in such a manner as to isolate the machine or equipment from the energy source, (4) affix lockout or tagout devices to each energy isolating device by authorized employee, (5) relieve, disconnect, restrain or otherwise render safe all stored or residual energy, (6) verify that isolation and de-energization of the machine or equipment have been accomplished: (a) Dry Department - On or about April 17th, 2024, the employer did not ensure that employees implemented energy control application steps prior to allowing them to perform service and maintenance tasks on the ROTO Chill Line 51, such as cleaning. The ROTO Chill Line 51 was not shut down or turned off prior to an employee engaging in this servicing and maintenance activity, exposing them to pinch/nip point hazards and amputation injuries. Abatement certification is required for this item in accordance with the requirements of 29 CFR 1903.19(c).