Translate
Violation Detail
Standard Cited: 19100333 B02 Selection and use of work practices
Inspection Nr: 1063288.015
Citation: 01003A
Citation Type: Serious
Abatement Status: Abatement Completed
Initial Penalty: $4,900.00
Current Penalty: $2,940.00
Issuance Date: 08/06/2015
Nr Instances: 1
Nr Exposed: 1
Abatement Date: 10/05/2015
Gravity: 10
Report ID: 0522000
Contest Date:
Final Order: 08/25/2015
Related Event Code (REC):
Emphasis:
| Type | Latest Event | Event Date | Penalty | Abatement Due Date | Citation Type | Failure to Abate Inspection |
|---|---|---|---|---|---|---|
| Penalty | P: Petition to Mod Abatement | $2,940.00 | 10/05/2015 | Serious | ||
| Penalty | I: Informal Settlement | 08/25/2015 | $2,940.00 | 09/23/2015 | Serious | |
| Penalty | Z: Issued | 08/06/2015 | $4,900.00 | 09/23/2015 | Serious |
Text For Citation: 01 Item/Group: 003A Hazard:
29 CFR 1910.333(b)(2): "Lockout and Tagging." While any employee is exposed to contact with parts of fixed electric equipment or circuits which have been deenergized, the circuits energizing the parts shall be locked out or tagged or both in accordance with the requirements of this paragraph. The requirements shall be followed in the order in which they are presented (i.e., paragraph (b)(2)(i) first, then paragraph (b)(2)(ii), etc.). Note 1: As used in this section, fixed equipment refers to equipment fastened in place or connected by permanent wiring methods. Note 2: Lockout and tagging procedures that comply with paragraphs (c) through (f) of 1910.147 will also be deemed to comply with paragraph (b)(2) of this section provided that: [1] The procedures address the electrical safety hazards covered by this Subpart; and [2] The procedures also incorporate the requirements of paragraphs (b)(2)(iii)(D) and (b)(2)(iv)(B) of this section. On or about May 11, 2015 an employee was exposed to contact parts of fixed electric equipment or circuits that had not been Lockout or Tagged out. In accordance with 29 CFR 1903.19(d), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in addition, documentation demonstrating that abatement is complete must be included with your certification. This documentation may include, but is not limited to, evidence of the purchase or repair of the equipment, photographic or video evidence, or written records.