Text For Citation: 01 Item/Group: 003 Hazard:

29 CFR 1910.147(d): Application of control. The established procedure for the application of energy control (the lockout or tagout procedures) did not cover the actions listed in and was not done in sequence as required by 29 CFR 1910.147(d)(1)-(6). On or about 27 September 2017, prior to starting work on the machines, to include cleaning of the rollers on the Flood Coater Machine, employees were not required to apply hazardous energy controls as follows: 1. Prepare for shut down by recognizing energy hazards and its controls, 2. Turn off and shut down the machines, 3. Physically locate and operate energy isolating devices in such a manner as to isolate the machine or equipment from the energy source, 4. Affix lockout or Tag-out devices to each energy isolating device, 5. Render safe all potentially hazardous stored or residual energy, 6. Verify that isolation and de-energization of the machine or equipment have been accomplished. The employer failed to take the necessary steps to ensure that their employees were properly protected against caught-in and amputation hazards from unexpected start-up. Hazardous energy controls (Lockout) were not implemented and performed to protect the employee from the caught-in hazard, likely to result in amputation. Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).