Text For Citation: 01 Item/Group: 002C Hazard:

29 CFR 1910.213(f)(1): Feed rolls and saws shall be protected by a hood or guard to prevent the hands of the operator from coming in contact with the in-running rolls at any point. The guard shall be constructed of heavy material, preferably metal, and the bottom of the guard shall come down to within three-eighths inch of the plane formed by the bottom or working surfaces of the feed rolls. This distance (three-eighths inch) may be increased to three-fourths inch, provided the lead edge of the hood is extended to be not less than 5 1/2 inches in front of the nip point between the front roll and the work. a) On or about May 18, 2022, at the facility located at N1308 Drumlin Drive, Campbellsport, WI, in Building 7, the Line 4 The Brute Chop Saw Operator is exposed to ingoing nip points where the material enters into the Barr Mullin Inc. The Brute Chop Saw feed opening feed rolls. b) On or about May 18, 2022, at the facility located at N1308 Drumlin Drive, Campbellsport, WI, in Building 4, the Line 1, The Brute Chop Saw Operator is exposed to ingoing nip points where the material enters into the Barr Mullin Inc. The Brute Chop Saw feed opening feed rolls. c) On or about May 18, 2022, at the facility located at N1308 Drumlin Drive, Campbellsport, WI, in Building 4, the Line 1, The Brute Chop Saw Stackers are exposed to the crush point created by the discharge feed rolls raising and lowering onto the cut material.