Text For Citation: 01 Item/Group: 002B Hazard:

29 CFR 1910.147(d): The established procedure for the application of energy control (the lockout or tagout procedures) did not cover the actions listed in and was not done in sequence as required by 29 CFR 1910.147(d)(1)-(6): a. Packaging Corporation of America - Ashland, Ohio: On or about January 7, 2024, employees were exposed to injury from rotating parts and pinch points created by moving components of equipment such as, but not limited to, the splicers, external and internal pre-heaters, modular facer, and corrugator rolls, at the wet-end of the corrugator line, in that the equipment was not locked out prior to threading the line for production. The employer did not ensure that energy control applications steps were implemented to control the equipment's hydraulic and electrical energy sources prior to the setup tasks - the employer did not: - Ensure that equipment was turned off or shut down. - Physically operate energy isolating devices to control energy sources and affix lockout device(s). - Ensure that all potentially hazardous stored or residual energy was relieved, disconnected, and rendered safe. - Verify that isolation and deenergization of the machine or equipment had been accomplished.