Text For Citation: 01 Item/Group: 001D Hazard:

29 CFR 1910.147(d):Application of control. The established procedures for the application of energy control (the lockout or tagout procedures) shall cover the following elements and actions and shall be done in the following sequence: (d)(2) Machine or equipment shutdown. The machine or equipment shall be turned off or shut down using the procedures established for the machine or equipment. An orderly shutdown must be utilized to avoid any additional or increased hazard(s) to employees as a result of the equipment stoppage. (d)(3) Machine or equipment isolation. All energy isolating devices that are needed to control the energy to the machine or equipment shall be physically located and operated in such a manner as to isolate the machine or equipment from the energy source(s). (d)(4) Lockout or tagout device application. (d)(4)(i) Lockout or tagout devices shall be affixed to each energy isolating device by authorized employees. 1910.147(d)(5) Stored energy. 1910.147(d)(6) Verification of isolation. Prior to starting work on machines or equipment that have been locked out or tagged out, the authorized employee shall verify that isolation and deenergization of the machine or equipment have been accomplished. a) On or about September 1, 2023, the employer did not ensure that elements (d)(2) through (d)(6) were followed by employees who were clearing jams on the Newman Trim Saw KM16H machine in that employees were removing jams while the saw was energized with the blade moving, resulting in an amputation.