Translate
Violation Detail
Standard Cited: 19100213 C02 Woodworking machinery requirements.
Inspection Nr: 1441550.015
Citation: 01001B
Citation Type: Serious
Abatement Date: 01/31/2020 2
Initial Penalty: $0.00
Current Penalty: $0.00
Issuance Date: 12/10/2019
Nr Instances: 1
Nr Exposed: 1
Related Event Code (REC): R
Gravity: 10
Report ID: 0522300
Contest Date:
Final Order: 01/07/2020
Emphasis:
| Type | Latest Event | Event Date | Penalty | Abatement Due Date | Citation Type | Failure to Abate Inspection |
|---|---|---|---|---|---|---|
| Penalty | I: Informal Settlement | 01/07/2020 | $0.00 | 01/31/2020 | Serious | |
| Penalty | Z: Issued | 12/10/2019 | $0.00 | 01/07/2020 | Serious |
Text For Citation: 01 Item/Group: 001B Hazard:
29 CFR 1910.213(c)(2): Each hand-fed circular ripsaw shall be furnished with a spreader to prevent material from squeezing the saw or being thrown back on the operator. The spreader shall be made of hard tempered steel, or its equivalent, and shall be thinner than the saw kerf. It shall be of sufficient width to provide adequate stiffness or rigidity to resist any reasonable side thrust or blow tending to bend or throw it out of position. The spreader shall be attached so that it will remain in true alignment with the saw even when either the saw or table is tilted. The provision of a spreader in connection with grooving, dadoing, or rabbeting is not required. On the completion of such operations, the spreader shall be immediately replaced. On or about October 22, 2019, the employer did not ensure a Bosch, Model 4100 table saw was furnished with spreader device to prevent material from squeezing the saw or being thrown back at the operator.