Violation Detail
Standard Cited: 95012901
Inspection Nr: 313059636
Citation: 01001
Citation Type: Other
Abatement Status: X
Initial Penalty: $100.00
Current Penalty:
Issuance Date: 10/19/2009
Nr Instances: 2
Nr Exposed: 3
Abatement Date: 11/13/2009
Gravity:
Report ID: 0453720
Contest Date:
Final Order:
Related Event Code (REC):
Emphasis:
| Type | Latest Event | Event Date | Penalty | Abatement Due Date | Citation Type | Failure to Abate Inspection |
|---|---|---|---|---|---|---|
| Penalty | I: Informal Settlement | 11/03/2009 | 11/13/2009 | Other | ||
| Penalty | Z: Issued | 10/19/2009 | $100.00 | 11/13/2009 | Serious |
Text For Citation: 01 Item/Group: 001 Hazard: LIFTING
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees conditions of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees: (a) Facility, warehouse - The rated load was not marked on the under the hook lifting device which was attached to a one ton hoist on the jib crane. (b) Facility, slashing area - The rated load was not marked on the under the hook lifting device which was attached to a two ton hoist on the overhead bridge crane. REF: ANSI B30.20-1985, Chapter 20-1, Section 20-1.2 Markings, Paragraph 20-1.2.1 (a)Rated load. The rated load of the lifting device shall be marked on the structure where it is visible. (b)Identification. A nameplate or other permanent marking shall be affixed displaying the following information: (1)Manufacturer's name (2)Serial number (3) Lifter weight, if over 100 lbs. (4)Rated load NOTE: Among other methods, one feasible and acceptable method to correct this hazard is to properly mark the rated load on the below the hook lifting device.
Translate