Text For Citation: 01 Item/Group: 001 Hazard: LIFTING

Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or likely to cause death or serious physical harm to his employees in that employees were exposed to: (a) Auto repair shop: On or about March 30, 2010 and at times prior thereto, employees were exposed to a struck by and crushing hazard while elevating vehicles using a Globe lift with a non-functioning lock on a lifting arm. (b) Auto repair shop: On or about March 30, 2010 and at times prior thereto, employees were exposed to a struck by and crushing hazard while elevating vehicles using Globe and Gilbarco lifts which had missing or damaged pads on the adjustable arm extensions. (c) Auto repair shop: On or about March 30, 2010 and at times prior thereto, employees were exposed to a struck by and crushing hazard while elevating vehicles using a Rotary 4 post auto lift with damaged sheave bearing and shafts. (d) Auto repair shop: On or about March 30, 2010 and at times prior thereto, employees were exposed to a struck by and crushing hazard while operating a below ground, hydraulic Weaver lift with missing locks, a pivoting front post, and extensive hydraulic leaks. Abatement Note: Among other methods, one feasible and acceptable method to correct the hazards noted is to follow the requirements in ANSI/ALI ALOIM 2008 which include, among other requirements, the following: 1. Institute a preventive maintenance program according to the manufacturer's specifications. 2. Provide training to employees on proper use and care of the lifts. 3. Schedule and complete all periodic and annual inspections. Abatement Note: Abatement certification and documentation is required for this item.