Text For Citation: 01 Item/Group: 001 Hazard: STRUCK BY

Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to THE HAZARD OF BEING STRUCK-BY: a)Injection Molding Dept., on or about 6/14/05: There were no inspections conducted on two North American two ton underhung cranes. Among other methods, one feasible and acceptable abatement method to correct this hazard is to: 1.Inspect the two cranes in accordance with ANSI B30.17-1985, Section 17-2.1. b)Tool Room, on or about 6/14/05: A bridge rail with a CM Lodestar 2 ton overhead hoist attached had no rated load markings on the rail. Among other methods, one feasible and acceptable abatement method to correct this hazard is to: 1.Mark the rated load markings on the bridge rail in accordance with ANSI B30.11-1980, Section 11-1.1.2. c)Tool Room, on or about 6/14/05: There were no inspections conducted on a CM Lodestar 2 ton overhead hoist attached to a bridge rail. Among other methods, on feasible and acceptable abatement method to correct this hazard is to: 1.Inspect the overhead hoist in accordance with ANSI B30.16-1993, Section 16- 2.1. Abatement certification must be submitted for these items.