Powered by GoogleTranslate

Violation Detail

Standard Cited: 6A0001 General Duty Clause

Inspection Nr: 301338380

Citation: 01001

Citation Type: Serious

Abatement Status: X

Initial Penalty: $600.00

Current Penalty: $600.00

Issuance Date: 12/26/2002

Nr Instances: 1

Nr Exposed: 2

Abatement Date: 01/23/2003

Gravity: 02

Report ID: 0257260

Contest Date:

Final Order:

Related Event Code (REC):

Emphasis:



Text For Citation: 01 Item/Group: 001 Hazard: STRUCK BY

Section 6(a) of the Puerto Rico Occupational Safety and Health Act: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or physical harm to employees by which employees were exposed to: Seccion 6(a) de la Ley de Seguridad y Salud en el Trabajo de Puerto Rico: El patrono no proveyo empleo y un sitio de empleo libre de riesgos reconocidos que esten causando o que puedan causar muerte o dano fisico a los empleados, por cuanto empleados estaban expuestos a: At the first aisle in the front and back area of the warehouse, there were two loose and unstable metal plates with approximately 64" length by 64 " wide and 1" 1/2" of depth, located in the holes on the floor. An employee was walking and another employee was driving with a forklift trademark Raymond, model 261-OPC 30, and serial number 261- 02-01812. They were storing and checking merchandise. Hazard: Falling load and toppled of the forklift. Among other correction methods, one feasible and acceptable to correct this hazard is to provide a fixed cover to level the floor. En el primer pasillo del almacen en la parte del frente y en la parte de atras, habian dos placas de metal sueltas e inestables con aproximadamente 64" de largo x 64" de ancho y 1" 1/2 " de profundidad, localizada sobre los huecos del piso. Un empleado estaba caminando y otro empleado conduciendo un montacargas marca Raymond, modelo 261- OPC 30, y numero de serie 261-02-01812. Ellos estaban almacenando y verificando mercancia. Riesgo: Caida de la carga y vuelco del montacargas. Entre otros metodos de correccion, uno factible y aceptable para corregir este riesgo es proveer una cubierta fija para nivelar.

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close