Violation Detail
Standard Cited: 5A0001 OSH Act General Duty Paragraph
Inspection Nr: 102616034
Citation: 01001
Citation Type: Serious
Abatement Date: 03/16/1990 X
Initial Penalty: $490.00
Current Penalty: $490.00
Issuance Date: 02/27/1990
Nr Instances: 1
Nr Exposed: 2
Related Event Code (REC):
Gravity: 07
Report ID: 0523310
Contest Date: 03/21/1990
Final Order: 09/17/1990
Emphasis:
Type | Latest Event | Event Date | Penalty | Abatement Due Date | Citation Type | Failure to Abate Inspection |
---|---|---|---|---|---|---|
Penalty | F: Formal Settlement | 09/17/1990 | $490.00 | 03/16/1990 | Serious | |
Penalty | Z: Issued | 02/27/1990 | $490.00 | 03/16/1990 | Serious |
Text For Citation: 01 Item/Group: 001 Hazard: CRUSHING
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: a) Hazard of crushing injury/death when entering/exiting through the west overhead door to the "Cat Shed" without proper protection. Among other methods of abatement would include: 1) A constant pressure actuation switch. This would always be operated in sight of the door so that it could be released and manually reversed if an obstruction was hit. 2) Installation of a reversing edge switch. This would allow an automatic closing control out of sight of the door, but would immediately reverse the direction of the door upon striking an obstruction. A variation to this option would be the use of photoelectric cells that would reverse the door when an obstruction was encountered by the beam. 3) A three-button control switch. If the following conditions are also met: a) It is provided with a permanent placard adjacent to the switch with the following warning letters at least 1/4" high: WARNING TO PREVENT ENTRAPMENT DO NOT START DOOR DOWNWARD UNLESS DOORWAY IS CLEAR b) The control station and placard are located within sight of the doorway. c) Automatic closing controls are not also installed. d) Operator must remain at the control station and observe the door until the door is fully closed.