Question: Now that OSHA has rescinded STD 03-00-001, what do residential construction employers have to do to protect employees from fall hazards?

Answer:

• Employees working six (6) feet or more above lower levels must be protected by conventional fall protection methods listed in 1926.501(b)(13) ( i.e., guardrail systems, safety net systems, or personal fall arrest systems ) or alternative fall protection measures allowed by other provisions of 29 CFR 1926.501(b) for particular types of work.
• An example of an alternative fall protection measure allowed under 1926.501(b) is the use of warning lines and safety monitoring systems during the performance of roofing work on low-sloped roofs. (4 in 12 pitch or less). (See 1926.501(b)(10)).
• OSHA allows the use of an effective fall restraint system in lieu of a personal fall arrest system. To be effective, a fall restraint system must be rigged to prevent a worker from reaching a fall hazard and falling over the edge. A fall restraint system may consist of a full body harness or body belt that is connected to an anchor point at the center of a roof by a lanyard of a length that will not allow a worker to physically reach the edge of the roof.
• When the employer can demonstrate that it is infeasible or creates a greater hazard to use required fall protection systems, a qualified person must develop a written site-specific fall protection plan in accordance with 1926.502(k) that, among other things, specifies the alternative fall protection methods that will be used to protect workers from falls.