1
06/19/2014 Clarification regarding shop installed continuous bent plate in steel erection
2
11/03/2005 Slip resistance of skeletal structural steel.
3
03/11/2004 Prohibition of installation of sheer connectors and pour-stop angles to top flange of steel steel beams prior to decking.
4
03/11/2004 Prohibition of installation of sheer connectors and pour-stop angles to top flange of steel steel beams prior to decking.
5
03/11/2004
Prohibition of installation of sheer connectors and pour-stop angles to top flange of steel steel beams prior to decking.
6
01/23/2004 Compliance of shop-installed steel angle or bent plates running along the length of the top flange of a perimeter beam.
7
12/24/2003 Evaluation of shop-installed angle iron on the top beam flange in Steel Erection.
8
12/24/2003 Evaluation of shop-installed angle iron on the top beam flange in Steel Erection.
9
12/11/2003 "Threaded studs" are prohibited from being installed prior to decking when they project.
10
12/11/2003 "Threaded studs" are prohibited from being installed prior to decking when they project.
11
01/23/2003 Sheer connector requirements in the steel erection standard to bridge repair/rehabilitation.
12
04/08/2002 Fall protection requirements for shop-installed shear connectors at 20 feet above ground or a lower level.
13
04/08/2002 Fall protection requirements for shop-installed shear connectors at 20 feet above ground or a lower level.
14
12/27/2001 Bridge construction will not be exempted from the sheer connector requirements of 1926.754(c)(1).
15
12/11/2001 Installation of the HBS Composite Action System's continous plate prior to erection of beam poses tripping hazard.
16
07/05/2001 Request for variance on tripping hazards for shear connectors.
17
05/16/2001 Development of slip-resistance testing methods on structural steel.
