Occupational Safety and Health Administration OSHA

Device Fabrication

Hard Bake

After developing, an additional baking process or "hard bake" is performed to harden the remaining photoresist to a finish much like the enamel on an automobile. The photoresist is then ready to protect the underlying SiO2 during etching.

The following are the potential hazards of hard baking.

Back to Top

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.