STODDARD SOLVENT | Occupational Safety and Health Administration

STODDARD SOLVENT†

Chemical Identification
Chemical Identification
CAS #	8052-41-3
Formula	Mixture
Synonyms	dry cleaning safety solvent; mineral spirits; petroleum solvent; spotting naphtha

Physical Properties
Physical Properties
Physical description	Colorless liquid with a kerosene-like odor.
Boiling point	309-396°F	Molecular weight	varies
Freezing point/melting point	102-110°F	Vapor pressure
Flash point	102-110°F	Vapor density
Specific gravity	0.78	Ionization potential
Lower explosive limit (LEL)	0.8%	Upper explosive limit (UEL)	5%
NFPA health rating	1	NFPA fire rating	2
NFPA reactivity rating	0	NFPA special instruction
Vapor hazard ratio (VHR)
Historical exceedance percentage
Target organs

Monitoring Methods Used by OSHA
Monitoring Methods Used by OSHA
Analyte code (IMIS no.)	2270
Sampling group	OVSG-1
Sampler/Sampling media	CSC tube (100/50 mg) [SKC 226-01]
Sampling time^*	15 min
Sampling volume (TWA)^*	3 L
Sampling flow rate (TWA)^*	0.2 L/min
Sampling volume (STEL/Peak/C)^*
Sampling flow rate (STEL/Peak/C)^*
Analytical method instruments	GC-FID
Method reference	OSHA 48 (fully validated)
Notes
Special requirements

^* All sampling instructions above are recommended guidelines for OSHA Compliance Safety and Health Officers (CSHOs), please see the corresponding OSHA method reference for complete details.

Wipe Method
Wipe Method
Sampler/Sampling media

Bulk Method
Bulk Method

On-Site Screening Techniques
On-Site Screening Techniques
Device
Model/Type
Sampling information (see manufacturer instructions)

Exposure Limits
Exposure Limits
OSHA PEL 8-hour TWA (ST) STEL (C) Ceiling Peak		NIOSH REL Up to 10-hour TWA (ST) STEL (C) Ceiling		ACGIH TLV© 8-hour TWA (ST) STEL (C) Ceiling		CAL/OSHA PEL 8-hour TWA (ST) STEL (C) Ceiling Peak
PEL-TWA	500 ppm (2900 mg/m³)	REL-TWA	350 mg/m³	TLV-TWA	100 ppm [1980]	PEL-TWA	100 ppm (525 mg/m³)
PEL-STEL		REL-STEL		TLV-STEL		PEL-STEL
PEL-C		REL-C	1800 mg/m³ [15 minutes]	TLV-C		PEL-C
Skin notation	N	Skin notation	N	Skin notation	N	Skin notation	N
Notes: The OSHA Construction and Maritime Industries PEL is 200 ppm (1150 mg/m³) as an 8 hr TWA. See 29 CFR 1910.1000 Table Z-1, 29 CFR 1926.55 Table 1 and 29 CFR 1915.1000 Table Z-Shipyards.		Notes:		Notes:		Notes:
Health factors: See NIH-NLM PubChem.		IDLH	20,000 mg/m³
Carcinogenic classifications: Not listed		Notes:

AIHA emergency response planning guidelines - ERPG-1/ERPG-2/ERPG-3:

Additional Resources and Literature References
Additional Resources and Literature References
NOAA: CAMEO Chemicals - Stoddard solvent NIOSH: Pocket Guide to Chemical Hazards - Stoddard solvent Literature References ACGIH: Documentation of the Threshold Limit Values (TLVs) and Biological Exposure Indices (BEIs) - Stoddard Solvent. See annual publication for most recent information. ATSDR: Toxicological Profile for Stoddard Solvent [3 MB PDF, 169 pages]. 1995. Bazylewicz-Walczak, B., Marzal-Wisniewska, M. and Siuda, A.: The psychological effects of chronic exposure to white spirit in rubber industry workers. Pol. J. Occup. Med. 3(1): 117-127, 1990. Järnberg, J., Johanson, G., Lof, A. and Stahlbom, B.: Toxicokinetics of 1,2,4-trimethylbenzene in humans exposed to vapors of white spirit: comparison with exposure to 1,2,4-trimethylbenzene alone. Arch. Toxicol. 72(8): 483-491, 1998. NTP: NTP Technical Report on the Toxicology and Carcinogenesis Studies of Stoddard Solvent IIC (CAS No. 64742-88-7) in F344/N Rats and B6C3F1 Mice (Inhalation Studies). Natl. Toxicol. Program Tech. Rep. Ser. (519): 1-274, September 2004. NIOSH: Occupational Health Guideline for Stoddard Solvent. 1978.

Last Updated Date : 07/15/2022

Group Sampling Information
Sampling Media	Sampling Time (If there are exceptions they will be in Notes)	TWA Sampling Volume (If there are exceptions they will be in Notes)	TWA Flow Rate (If there are exceptions they will be in Notes)
CSC Tube (100/50 mg sections, 20/40 mesh), [SKC 226-01]	240 min	12 L	0.05 L/min

Analytes Sampling Information
Analytes	IMIS Code	Wipe Sampling
Isobutyl Acetate	1534	No
n-Butyl Acetate	0440	No
sec-Butyl Acetate	0441	No
tert-Butyl Acetate	0442	No
Toluene**	2460	No
Ethyl Benzene	1080	No
Perchloroethylene (Tetrachloroethylene)**	2020	No
Trichloroethylene**	2490	No
Xylene	2590	No
Trimethylbenzene	2505	No
Benzene***	0320	No
Ethyl Acetate****	1040	No
n-Propyl Acetate‡	2180	No
Pentane‡‡	1990	No
Cyclohexane‡‡‡	0810	No
Heptane*	1371	No
n-Hexane‡‡‡‡	1380	No
Nonane*	N807	No
Octane*	1957	No

Notes

Request any (up to three (3)) of these analytes together.

Alternatively request IMIS Code Q115 and SLTC will report any significant amounts of these analytes.

Results for unrequested analytes in this group will be reported if significant amount are found.

Toluene, sec-Butyl Acetate, Benzene and Isobutyl Alcohol all have/are known interferences. Please indicate on the 91A which of these compounds are known to be present.

There is no need to contact SLTC before sampling.

*80 min (4L)

**Peak sampling 1 min (0.05 L) and Ceiling sampling 5 min (0.25 L)

***STEL sampling 15 min (0.75 L)

****120 min (6 L)

‡200 min (10 L)

‡‡45 min (2.25 L)

‡‡‡190 min (9.5 L)

‡‡‡‡98 min (4.9 L)