Label abbreviations descriptions

BARIUM SULFATE†

Chemical Identification
CAS # 7727-43-7
Formula

BaSO₄
Synonyms

artificial barite; barite; barium salt of sulfuric acid; barytes (natural)

Physical Properties
Physical description White or yellowish, odorless powder.
Boiling point 2912°F (decomposes) Molecular weight 233.4
Freezing point/melting point 2876°F Vapor pressure 0 mmHg (approx)
Flash point Vapor density
Specific gravity 4.25-4.5 Ionization potential
Lower explosive limit (LEL) Upper explosive limit (UEL)
NFPA health rating NFPA fire rating
NFPA reactivity rating NFPA special instruction
Vapor hazard ratio (VHR)
Historical exceedance percentage
Target organs

Monitoring Methods Used by OSHA
Analyte code (IMIS no.) B101 (total); request using analyte code 9135 B104 (resp); request using analyte code 9030
Sampling group
Sampler/Sampling media Tared low-ash 37 mm PVC filter, 5 microns [SLTC108] Tared low-ash 37 mm PVC filter, 5 microns, preceded by 10 mm nylon Dorr-Oliver cyclone for respirable samples. [SLTC108]
Sampling time*

240-480 min

240-480 min
Sampling volume (TWA)*

960 L

816 L
Sampling flow rate (TWA)*

2 L/min

1.7 L/min ±5%
Sampling volume (STEL/Peak/C)*
Sampling flow rate (STEL/Peak/C)*
Analytical method instruments Gravimetric Gravimetric
Method reference OSHA PV2121 (partially validated) OSHA PV2121 (partially validated)
Notes

Samples collected for this compound are analyzed gravimetrically. Results reported for the requested compound will be qualified based on the assumption that the material sampled is as identified by the compliance officer using available documentation of materials and processes; no further work on the sample will be performed due to method limitations.

Samples collected for this compound are analyzed gravimetrically. Results reported for the requested compound will be qualified based on the assumption that the material sampled is as identified by the compliance officer using available documentation of materials and processes; no further work on the sample will be performed due to method limitations. The standard applies to the Respirable Fraction. Samples must be collected with a Dorr-Oliver cyclone.
Special requirements

FOR TOTAL DUST SAMPLES, DO NOT USE A CYCLONE!!

* All sampling instructions above are recommended guidelines for OSHA Compliance Safety and Health Officers (CSHOs), please see the corresponding OSHA method reference for complete details.

Bulk/Wipe Method
Wipe Sampler/Sampling media
Bulk Method

On-Site Screening Techniques
Device
Model/Type
Sampling information
(see manufacturer instructions)

Exposure Limits
OSHA PEL
8-hour TWA
(ST) STEL
(C) Ceiling
Peak
NIOSH REL
Up to 10-hour TWA
(ST) STEL
(C) Ceiling
ACGIH TLV©
8-hour TWA
(ST) STEL
(C) Ceiling
CAL/OSHA PEL
8-hour TWA
(ST) STEL
(C) Ceiling
Peak
PEL-TWA

15 mg/m³ (total dust), 5 mg/m³ (respirable fraction)

 REL-TWA

10 mg/m³ (total dust), 5 mg/m³ (respirable fraction)

 TLV-TWA PEL-TWA

10 mg/m³ (total dust), 5 mg/m³ (respirable fraction)
PEL-STEL REL-STEL TLV-STEL PEL-STEL
PEL-C REL-C TLV-C PEL-C
Skin notation

N

 Skin notation

N

 Skin notation

N

 Skin notation

N
Notes:

See 29 CFR 1910.1000 Table Z-1.

 Notes: Notes:

Visit the ACGIH TLV site for specific data
The value is for particulate matter containing no asbestos and <1% crystalline silica.

 Notes:

As Particulates not otherwise regulated. See footnote [n].
Health factors:  See NIH-NLM PubChem. IDLH
Carcinogenic classifications: Not listed Notes:
AIHA emergency response planning guidelines - ERPG-1/ERPG-2/ERPG-3:

Additional Resources and Literature References

Last Updated Date : 04/02/2024