# Title
 1  2010 - 03/02/2010 - Interpretation of OSHA Fall Protection Exemption (29 CFR 1926.500(a)(1)) during inspection, investigation, and assessment activities.
 2  2010 - 03/02/2010 - Whether an employer can use a controlled access zone during curtain wall installation.
 3  2006 - 09/05/2006 - When protective measures must be installed after a hole is created on a construction worksite.
 4  2005 - 04/11/2005 - Scaffolding/shoring.
 5  2004 - 03/10/2004 - Fall protection is not required where there is no feasible means of providing it while working on vehicles or trailers.
 6  2003 - 09/26/2003 - Compliance of using warning lines and/or control access zones for fall protection on roofs with a slope greater than 4:12.
 7  2003 - 07/07/2003 - Requirements for fall protection when ladder jack scaffolds are used for residential and commercial construction.
 8  2003 - 05/21/2003 - Fall protection requirements for an employee working from a ladder on a walking/working surface other than the ground.
 9  2002 - 11/15/2002 - Fall protection requirements for employees, other than roofers, working on low-slope roofs.
 10  2001 - 04/10/2001 - Requirements of Interim Fall Protection Compliance Guidelines for Residential Construction for guardrails and fall protection during roofing work.
 11  2000 - 08/14/2000 - Clarification of the terms "hole" versus "unprotected sides or edges."
 12  2000 - 08/14/2000 - Fall protection for various lift-devices; restraint, positioning, fall arrest and rescue requirements; maintenance vs. construction examples.
 13  2000 - 05/12/2000 - Fall protection non-conforming guardrail criteria for application of a de minimis policy.
 14  1996 - 04/02/1996 - Portable ladders.
 15  1995 - 09/25/1995 - OSHA's New Fall Protection Standard for the Construction Industry.
 16  1995 - 09/25/1995 - OSHA's new fall protection standards for construction will prohibit use of safety belts with side dee rings as part of a personal fall arrest system.
 17  1995 - 09/25/1995 - Review of a new product, "The Safety Boot".
 18  1995 - 08/28/1995 - The frequency of the load measuring system when testing fall arrest equipment should be set at 500 Hz.
 19  1993 - 03/24/1993 - Request for approval of guardrail system.
 20  1991 - 10/01/1991 - Stairways used in construction.
 21  1988 - 03/31/1988 - Failure of Wire Rope and Banding Steel Guardrails to provide Protection.
 22  1986 - 04/10/1986 - Clarification of our standard railing requirements.
 23  1986 - 03/20/1986 - Design criteria for a standard railing.
 24  1985 - 11/14/1985 - Standard railing requirements.
 25  1984 - 11/02/1984 - Strength criteria for guardrail and stairway systems.
 26  1984 - 09/18/1984 - Ball-type handrail system.
 27  1984 - 07/24/1984 - Wire rope and/or cable as a method of perimeter protection for a building under construction.
 28  1981 - 06/24/1981 - Guarding Low-Pitched-Roof Perimeters.
 29  1981 - 04/14/1981 - Perimeter guarding of low-pitched roofs.
 30  1981 - 03/16/1981 - Certain built-up roofing requirements.
 31  1979 - 07/09/1979 - Use of Steel Band in Guardrails.
 32  1979 - 01/09/1979 - Steel Banding as Guardrails.
 33  1978 - 03/22/1978 - Requirements for toeboards.
 34  1974 - 10/21/1974 - Use of stilts.
 35  1973 - 12/23/1973 - 1926.500, Guardrails, handrails & guards.