US Dept of Labor

Occupational Safety & Health AdministrationWe Can Help

OSHA News Release - (Archived) Table of Contents
Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.
Trade News Release Banner Image

National News Release 07-1255-NAT
Aug. 16, 2007
Contact: Sharon Worthy     David Sims
Phone: (202) 693-4676     (202) 693-1898

U.S. Department of Labor's OSHA proposes $2.78 million fine against Cintas Corp. following Tulsa, Okla., employee death in industrial dryer
Alabama, Arkansas, Ohio and Washington facilities also inspected

WASHINGTON -- The U.S. Department of Labor's Occupational Safety and Health Administration (OSHA) today proposed $2.78 million in penalties against Ohio-based Cintas Corp. following an inspection into the March 2007 employee death at the Cintas laundry facility in Tulsa, Okla. The employee was killed when he fell into an operating industrial dryer while clearing a jam of wet laundry on a conveyor that carries the laundry from the washer into the dryer.

Cintas is the largest uniform supplier in North America, with more than 400 facilities employing more than 34,000 people. The facility in Tulsa has 160 employees.

"Plant management at the Cintas Tulsa laundry facility ignored safety and health rules that could have prevented the death of this employee," said Assistant Secretary of Labor for OSHA Edwin G. Foulke Jr.

Forty-two willful, instance-by-instance citations allege violations of the OSHA lockout/tagout standard for the failures to shut down and to lock out power to the equipment before clearing jams, and to train four employees responsible to clear jams that lockout/tagout applies and how to perform the operations. One repeat citation alleges the failure to protect employees from being struck or pinned by the conveyor. Three serious citations allege the failures to protect employees from falls, to have a qualified person inspect the lockout/tagout procedures and to certify the procedures as required.

In a separate case, OSHA today issued five repeat and two serious citations with penalties totaling $117,500 for violations of the lockout/tagout and machine guarding standards found at the Cintas Columbus, Ohio, facility. OSHA also has opened investigations in Arkansas and Alabama. Washington, an OSHA State Plan state, has issued four citations with proposed fines totaling $13,650, alleging violations for similar hazards at the Yakima Cintas facility.

A willful violation is one committed with intentional disregard of the requirements of the Occupational Safety and Health Act or plain indifference to employee safety or health. A serious violation is one that could cause death or serious physical harm to employees, and the employer knew or should have known of the hazard.

Cintas has 15 working days from receipt of the citations to contest the citations and the proposed penalties before the independent Occupational Safety and Health Review Commission.

OSHA's mission is to assure the safety and health of America's working men and women by preventing injuries, illnesses and fatalities. The agency has a vigorous enforcement program, having conducted more than 38,000 inspections last year and exceeding its inspection goals in each of the last seven years. In fiscal year 2006, OSHA found nearly 84,000 violations of its standards and regulations. Employers and employees with questions regarding workplace safety and health standards may call OSHA's toll-free hotline at (800) 321-6742.


U.S. Labor Department releases are accessible on the Internet at The information in this news release will be made available in alternate format upon request (large print, Braille, audio tape or disc) from the COAST office. Please specify which news release when placing your request. Call (202) 693-7765 or TTY (202) 693-7755. DOL is committed to providing America's employers and employees with easy access to understandable information on how to comply with its laws and regulations. For more information, please visit
Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

OSHA News Release - (Archived) Table of Contents

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.